RI-STU-650A Datasheet, PDF (1/1 Pages) Texas Instruments – HF Reader System Series 6000 S6500 Long Range Reader Module

RADIO FREQUENCY IDENTIFICATION SYSTEMS
Data Sheet
HF Reader System Series 6000
S6500 Long Range Reader Module
Specifications:
Part number
Operating Frequency
Supported Transponders
Supply voltage
Power consumption
Transmitter power
Transmitter modulation
Antenna connection
Antenna Impedance
Receive channels
Communication Interfaces
Address setting for interface
Communication Parameters
Communication Protocol
Memory
Outputs
Inputs
Optical Indicators
Synchronization
Operating Temperature
Storage Temperature
Vibration
Dimensions (L x W x H)
Weight
RI-STU-650A
13.56MHz ± 7kHz
Tag-it HF, Tag-it HF-I, ISO 15693 compliant Transponders
24V DC +5% / -1% (Noise Ripple: max. 20mV)
Max. 60W
0.5W to 10W ± 1dB (adjustable by software in 0.25W steps)
above 4W output power an additional heat sink 0.8K/W is necessary
AM (10% - 30%) ± 6% or 100% (adjustable by software)
Basic antenna (TX/RX)
Complementary antenna (RX only)::
1 x SMA female
1 x SMA female
50 Ohm at 13.56MHz
ASK 423.75kHz and FSK 423.75kHz / 484.29kHz for both antennas
(adjustable by software)
RS232 or RS485 (set by jumper)
Optional: - 3-position DIP switch (up to 8 addresses)
- Software (up to 254 addresses)
Up to 115kBits, 8 data bits, even/odd/no parity
ISO Host Protocol
EEPROM 1kByte (for parameters; up to 10,000 write cycles)
RAM
256 kByte (for data)
Flash
512 kByte (for firmware; update via communication interface)
2 opto-coupled:
1 relay:
24V DC / 30mA
24V DC / 60W
2 opto-coupled:
max. 24V DC / 20mA
5 LED’s for status diagnostics
Protocol synchronization via I/O
-20°C to +65°C
-40°C to +85°C
EN60068-2-6 (10Hz to 200Hz: 0.15mm/2g)
160mm x 120mm x 67mm
650 g
For more information, contact the sales office or distributor nearest you. This contact information can be found
on our web site at:
http://www.ti-rfid.com
Texas Instruments reserves the right to change its products and services at any time without notice. TI provides customer assistance in various
technical areas, but does not have full access to data concerning the uses and applications of customers products. Therefore, TI assumes no
responsibility for customer product design or for infringement of patents and/or the rights of third parties, which may result from assistance
provided by TI.
© Copyright 2001 Texas Instruments Incorporated.
11-06-22-099 07/01