RI-I01-112A Datasheet, PDF (1/2 Pages) Texas Instruments – Tag-it HF-I Transponder Inlay - Square -

RADIO FREQUENCY IDENTIFICATION SYSTEMS
Tag-it^ä HF-I Transponder Inlay
- Square -
The Tag-it HF-I Transponder Inlay is compliant with
the ISO/IEC 15693 standard. With a user memory of
2k bits, organized in 64 blocks, the Tag-it HF-I
Transponder Inlays allows advanced solutions for a
variety of applications, including product authenti-
cation, ticketing, library management, supply chain
management etc. The thin and flexible Tag-it HF-I
Transponder Inlays can be easily converted into
paper or plastic labels.
Specifications:
Part Number
RI-I01-112A
RI-I01-112B
Supported Standard
Recommended Operating frequency
ISO 15693-2,-3
13.56 MHz
Passive Resonance Frequency (at +25°C)
Typ. required activation field strength read (at +25°C)
Typ. required activation field strength write (at +25°C)
Factory programmed Read Only Number
Memory (user programmable)
Typical programming cycles (at +25°C)
Data retention time (at +55°C)
Simultaneous Identification of Tags
Antenna size
Foil width
Foil pitch
Thickness
Base material
Smallest bending radius allowed
Operating temperature
Storage temperature (single inlay)
Storage temperature (on reel)
Delivery
13.86 MHz ± 200kHz (includes
frequency offset to compensate
further integration into paper)
14.4 MHz ± 200kHz (includes
frequency offset to compensate
PVC lamination)
98 dBµA/m ^#
101 dBµA/m ^#
98 dBµA/m *
101 dBµA/m *
64 bits
2k bits organized in 64 x 32-bit blocks
100,000
> 10 years
Up to 50 tags per second (reader/antenna dependent)
45 mm x 45 mm (∼1.77 in x ∼1.77 in)
48 mm ± 0.5 mm (1.89 in ± 0.02 in)
48 mm +0.1mm/-0.4mm (∼1.89 in)
Chip: 0.355mm (∼0.014 in)
Antenna: 0.085mm (∼0.0033 in)
Substrate: PET (Polyethylenetherephtalate)
Antenna: Aluminum
18 mm (∼0.71 in)
-25°C to +70°C
-40°C to +85°C (warpage may occur at upper temperature range)
-40°C to +40°C
Single row tape wound on cardboard reel with 500 mm diameter
Reel outer width: approx. 60 mm (∼2.36 in)
Reel inner width: approx. 50 mm (∼1.97 in)
Hub diameter: 76.2 mm (3 in)
Typical quantity of good units per reel
5,000
Note: For highest possible read-out coverage we recommend to operate readers at a modulation depth of 20% or higher
# _{After integration into paper; * After PVC Lamination}
For more information, contact the sales office or distributor nearest you. This contact information can be found
on our web site at:
http://www.ti-rfid.com