English
Language : 

PTH05000W_15 Datasheet, PDF (1/14 Pages) Texas Instruments – 6-A, 5-V Input Non-Isolated Wide-Output Adjust Power Module
PTH05000W —5-V Input
6-A, 5-V Input Non-Isolated
Wide-Output Adjust Power Module
SLTS201C – MAY 2003 – REVISED DECEMBER 2003
NOMINAL SIZE = 0.75 in x 0.5 in
(19,05 mm x 12,7 mm)
Features
• Up to 6-A Output Current
• 5-V Input Voltage
• Wide-Output Voltage Adjust
(0.9 V to 3.6 V)
• Efficiencies up to 94 %
• 160 W/in³ Power Density
• On/Off Inhibit
• Under-Voltage Lockout
• Output Current Limit
• Pre-Bias Startup Capability
• Over-Temperature Protection
• Surface Mountable
• Operating Temp: –40 to +85 °C
• Safety Agency Approvals (Pending):
UL 1950, CSA 22.2 950, EN60950
& VDE
Description
The PTH05000 series of non-isolated
power modules are small in size and high
on performance. Using double-sided sur-
face mount construction and synchronous
rectification technology, these regulators
deliver up to 6 A of output current while
occupying a PCB area of about half the
size of a standard postage stamp. They
are an ideal choice for applications where
space, performance and cost are impor-
tant design constraints.
The series operates from an input
voltage of 5 V to provide step-down
power conversion to any output voltage
over the range, 0.9 V to 3.6 V. The out-
put voltage of the PTH05000W is set
within this range using a single resistor.
Operating features include an on/off
inhibit, output voltage adjust (trim), an
output current limit, and over-tempera-
ture protection.
For high efficiency these parts employ
a synchronous rectifier output stage. An
output pre-bias holdoff capability ensures
that the output will not sink current dur-
ing startup.
Target applications include telecom,
industrial, and general purpose circuits,
including low-power dual-voltage systems
that use a DSP, microprocessor, or ASIC.
Package options include both through-
hole and surface mount configurations.
Pin Configuration
Pin Function
1 GND
2 Vin
3 Inhibit *
4 Vo Adjust
5 Vout
* Denotes negative logic:
Open = Output On
Ground = Output Off
Standard Application
Rset = Required to set the output voltage to a value
higher than 0.9 V. See spec. table for values.
Cin = Required 330 µF capacitor
Cout = Optional 100 µF capacitor
VIN
CIN
330 µF
(Required)
Inhibit
GND
1
5
PTH05000W
2
(Top View)
3
4
RSET
1 %, 0.1 W
(Required)
COUT
100 µF
Electrolytic
(Optional)
VOUT
GND
For technical support and further information visit http://power.ti.com