MSP430G2X01 Datasheet, PDF (1/47 Pages) Texas Instruments – MIXED SIGNAL MICROCONTROLLER

MSP430G2x01, MSP430G2x11
MIXED SIGNAL MICROCONTROLLER
D Low Supply Voltage Range 1.8 V to 3.6 V
D Ultralow Power Consumption
-- Active Mode: 220 µA at 1 MHz, 2.2 V
-- Standby Mode: 0.5 µA
-- Off Mode (RAM Retention): 0.1 µA
D Five Power-Saving Modes
D Ultrafast Wake-Up From Standby Mode in
Less Than 1 µs
D 16-Bit RISC Architecture, 62.5 ns
Instruction Cycle Time
D Basic Clock Module Configurations:
-- Internal Frequencies up to 16 MHz With
One Calibrated Frequency
-- Internal Very Low Power LF Oscillator
-- 32-kHz Crystal
-- External Digital Clock Source
D 16-Bit Timer_A With Two Capture/Compare
Registers
SLAS695B -- FEBRUARY 2010 -- REVISED MAY 2010
D Brownout Detector
D On-Chip Comparator for Analog Signal
Compare Function or Slope A/D (See
Table 1)
D Serial Onboard Programming,
No External Programming Voltage Needed
Programmable Code Protection by
Security Fuse
D On-Chip Emulation Logic With Spy-Bi-Wire
Interface
D Family Members details see Table 1
D Available in a 14-Pin Plastic Small-Outline
Thin Package (TSSOP), 14-Pin Plastic Dual
Inline Package (PDIP), and 16-Pin QFN
D For Complete Module Descriptions, See the
MSP430x2xx Family User’s Guide
description
The Texas Instruments MSP430 family of ultralow-power microcontrollers consists of several devices featuring
different sets of peripherals targeted for various applications. The architecture, combined with five low-power
modes, is optimized to achieve extended battery life in portable measurement applications. The device features
a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code
efficiency. The digitally controlled oscillator (DCO) allows wake-up from low-power modes to active mode in less
than 1 µs.
The MSP430G2x01/11 series is an ultralow-power mixed signal microcontroller with a built-in 16-bit timer and
ten I/O pins. The MSP430G2x11 family members have a versatile analog comparator. For configuration details
see Table 1.
Typical applications include low-cost sensor systems that capture analog signals, convert them to digital values,
and then process the data for display or for transmission to a host system.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCT PREVIEW information concerns products in the formative or
design phase of development. Characteristic data and other
specifications are design goals. Texas Instruments reserves the right to
change or discontinue these products without notice.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
Copyright  2010 Texas Instruments Incorporated
1