DK-LM3S9B96-FS8 Datasheet, PDF (1/5 Pages) Texas Instruments – Stellaris® Flash and SRAM Memory Expansion Board

DK-LM3S9B96-FS8 README
FIRST
Stellaris® Flash and SRAM Memory Expansion
Board
The Stellaris® Flash and SRAM memory expansion board (DK-LM3S9B96-FS8) provides an
easy way to evaluate the capabilities of the Stellaris External Peripheral Interface (EPI) using
the highly integrated DK-LM3S9B96 development platform.
Flash and SRAM Memory Expansion Board
Requirements
ƒ You have a DK-LM3S9B96 development platform
ƒ You have the Stellaris LM3S9B96 Development Kit Documentation and Software CD
Board Set-Up
The Flash and SRAM memory expansion board interfaces to the EPI interface of the
DK-LM3S9B96 development board using shared pins on the development board’s LCD
interface. Before installing the Flash and SRAM memory expansion board, you must remove
the jumpers from JP16-31 in the QVGA LCD section of the development board (this is all of
the jumpers). If the jumpers are not removed, the Flash and SRAM memory expansion board
cannot be installed on the DK-LM3S9B96 development board. See Figure 1. DK-LM3S9B96
Development Board.
With the jumpers removed, then remove any expansion board that is currently fitted to the
expansion connector. This includes both the SDRAM expansion board and the EPI breakout
expansion board.
Rev. 1.1
1