CY74FCT2543ATQCTE4 Datasheet, PDF (1/14 Pages) Texas Instruments – 8-BIT LATCHED TRANSCEIVER WITH 3-STATE OUTPUTS

D Function and Pinout Compatible With FCT
and F Logic
D 25-W Output Series Resistors to Reduce
Transmission-Line Reflection Noise
D Reduced V_OH (Typically = 3.3 V) Versions
of Equivalent FCT Functions
D Edge-Rate Control Circuitry for
Significantly Improved Noise
Characteristics
D I_off Supports Partial-Power-Down Mode
Operation
D Matched Rise and Fall Times
D Fully Compatible With TTL Input and
Output Logic Levels
D 12-mA Output Sink Current
15-mA Output Source Current
D Separation Controls for Data Flow in Each
Direction
D Back-to-Back Latches for Storage
D ESD Protection Exceeds JESD 22
– 2000-V Human-Body Model (A114-A)
– 200-V Machine Model (A115-A)
– 1000-V Charged-Device Model (C101)
D 3-State Outputs
CY74FCT2543T
8-BIT LATCHED TRANSCEIVER
WITH 3-STATE OUTPUTS
SCCS042C – SEPTEMBER 1994 – REVISED NOVEMBER 2001
Q OR SO PACKAGE
(TOP VIEW)
LEBA ₁
OEBA ₂
A₀ 3
A₁ 4
A₂ 5
A₃ 6
A₄ 7
A₅ 8
A₆ 9
A₇ 10
CEAB 11
GND 12
24 ^V_CC
23 ^CEBA
22 B₀
21 B₁
20 B₂
19 B₃
18 B₄
17 B₅
16 B₆
15 B₇
14 LEAB
13 OEAB
description
The CY74FCT2543T octal latched transceiver contains two sets of eight D-type latches. Separate latch enable
(LEAB, LEBA) and output enable (OEAB, OEBA) inputs permit each latch set to have independent control of
inputting and outputting in either direction of data flow. For example, for data flow from A to B, the A-to-B enable
(CEAB) input must be low to enter data from A or to take data from B, as indicated in the function table. With
CEAB low, a low signal on the A-to-B latch enable (LEAB) input makes the A-to-B latches transparent; a
subsequent low-to-high transition of LEAB puts the A latches in the storage mode and their outputs no longer
change with the A inputs. With CEAB and OEAB both low, the 3-state B output buffers are active and reflect
data present at the output of the A latches. Control of data from B to A is similar, but uses CEAB, LEAB, and
OEAB inputs. On-chip termination resistors at the outputs reduce system noise caused by reflections. The
CY74FCT2543T can replace the CY74FCT543T to reduce noise in an existing design.
This device is fully specified for partial-power-down applications using I_off. The I_off circuitry disables the outputs,
preventing damaging current backflow through the device when it is powered down.
Please be aware that an important notice concerning availability, standard warranty, and use in critical applications of
Texas Instruments semiconductor products and disclaimers thereto appears at the end of this data sheet.
PRODUCTION DATA information is current as of publication date.
Products conform to specifications per the terms of Texas Instruments
standard warranty. Production processing does not necessarily include
testing of all parameters.
• POST OFFICE BOX 655303 DALLAS, TEXAS 75265
Copyright  2001, Texas Instruments Incorporated
1