CC1110 Datasheet, PDF (1/203 Pages) Texas Instruments – True System-on-Chip with Low Power RF Transceiver and 8051 MCU

CC1110
True System-on-Chip with Low Power RF Transceiver and 8051 MCU
Applications
• 315/433/868 and 915 MHz ISM/SRD band
systems
• Low power telemetry
• Home and building automation
• AMR – Automatic Meter Reading
• Wireless alarm and security systems
• RKE – Two-way Remote Keyless Entry
• Consumer Electronics
• Wireless sensor networks
• Industrial monitoring and control
Product Description
The CC1110 is a low-cost true System-on-Chip
(SoC) device designed for low-power and low-
voltage wireless communication applications.
The CC1110 combines the excellent
performance of the state-of-the-art CC1100
RF transceiver with an industry-standard
enhanced 8051 MCU, 32 KB of in-system
programmable flash memory, 4 KB of RAM
and many other powerful features.
The CC1110 is highly suited for systems where
very low power consumption is required. This
is ensured by several advanced low-power
operating modes.
The CC1110 provides a tight integration
between the MCU core, software and the RF
transceiver, making this System-on-Chip
solution easy to use as well as improving
performance.
CC1110 is supported by a powerful integrated
development environment (IDE). In-circuit
interactive debugging is supported for the
industry standard IAR C-SPY IDE via a simple
two-wire serial interface.
CC1110 is based on Chipcon’s SmartRF04^®
technology platform in 0.18 µm CMOS.
The data sheet contains preliminary data, and supplementary data will be published at a later date. Chipcon
reserves the right to make changes at any time without notice in order to improve design and supply the best
possible product. The product at this point is not fully qualified.
Key Features
• High performance and low power 8051
microcontroller core, typically with 8x the
performance per MHz of a standard 8051
• High-performance RF transceiver core –
same as in the CC1100
• Frequency bands: 300-348 MHz, 400-464
MHz and 800-928 MHz
• Programmable data rate up to 500 kbps
• 32 KB in-system programmable flash
• 4 KB RAM
• 8-14 bits ADC with up to eight inputs
• 128-bit AES security coprocessor
• Powerful DMA functionality
• Two USARTs / SPI interfaces
• 16-bit timer + three 8-bit timers
• Hardware debug support
• 21 general I/O pins
• Wide supply voltage range (2.0V – 3.6V)
• High sensitivity (–110 dBm at 1.2 kbps)
• Programmable data rate up to 500 kbps
CC1110 PRELIMINARY Data Sheet (Rev. 1.01) SWRS033A
Page 1 of 202