SF2001G Datasheet, PDF (1/2 Pages) Taiwan Semiconductor Company, Ltd – 20.0 AMPS. Glass Passivated Super Fast Rectifiers

SF2001G thru SF2008G
®
SF2001G thru SF2008G
Pb
Pb Free Plating Product
20.0 Ampere Dual Unipolar-Doubler Polarity Superfast Recovery Diode
Features
¬ Fast switching for high efficiency
¬ Low forward voltage drop
¬ High current capability
¬ Low reverse leakage current
¬ High surge current capability
Mechanical Data
¬ Case: TO-220AB Heatsink
¬ Epoxy: UL 94V-0 rate flame retardant
¬ Terminals: Solderable per MIL-STD-202
method 208
¬ Polarity: As marked on body
¬ Mounting position: Any
¬ Weight: 2.24 gram approximately
TO-220AB
.419(10.66)
.387(9.85)
.139(3.55)
MIN
Unit : inch (mm)
.196(5.00)
.163(4.16)
.054(1.39)
.045(1.15)
.038(0.96)
.019(0.50)
.1(2.54)
.1(2.54)
.025(0.65)MAX
Case
Positive
Common Cathode
Case
Negative
Common Anode
Suffix "A"
Case
Doubler
Series Connection
Suffix "D"
MAXIMUM RATINGS AND ELECTRICAL CHARACTERISTICS
Rating at 25^oC ambient temperature unless otherwise specified.
Single phase, half wave, 60Hz, resistive or inductive load.
For capacitive load, derate current by 20%.
Common Cathode
Common Anode Suffix "A"
Anode and Cathode Coexistence Suffix "D"
Maximum Recurrent Peak Reverse Voltage
SF2001G SF2002G SF2004G SF2005G SF2006G SF2008G
SYMBOL SF2001GA SF2002GA SF2004GA SF2005GA SF2006GA SF2008GA UNIT
SF2001GD SF2002GD SF2004GD SF2005GD SF2006GD SF2008GD
VRRM
50
100
200
300
400
600
V
Maximum RMS Voltage
VRMS
35
70
140
210
280
420
V
Maximum DC Blocking Voltage
VDC
50
100
200
300
400
600
V
Maximum Average Forward Rectified
Current TC=125^oC
IF(AV)
20.0
A
Peak Forward Surge Current, 8.3ms single
Half sine-wave superimposed on rated load IFSM
200
(JEDEC method)
175
A
Maximum Instantaneous Forward Voltage
@ 10.0 A
Maximum DC Reverse Current @TJ=25^oC
At Rated DC Blocking Voltage @TJ=125^oC
Maximum Reverse Recovery Time (Note 1)
Typical junction Capacitance (Note 2)
Operating Junction and Storage
Temperature Range
VF
IR
Trr
CJ
TJ, TSTG
0.975
120
1.3
10.0
250
35
70
-55 to +150
1.5
V
uA
uA
nS
pF
o_C
NOTES : (1) Reverse recovery test conditions IF = 0.5A, IR = 1.0A, Irr = 0.25A.
(2) Measured at 1.0 MHz and applied reverse voltage of 4.0 Volts DC.
© 2006 Thinki Semiconductor Co.,Ltd.
Page 1/2
http://www.thinkisemi.com/