AMC3202DMF Datasheet, PDF (2/6 Pages) Tiger Electronic Co.,Ltd – 1.5A 280kHz Boost Regulators

BLOCK DIAGRAM AND PI N CONFIGURATION
AMC3202DMF
PIN DESCRIPTION
Pin No.
1
2
Pin Name
COMP
FB
Pin Function
Loop compensation pin. This pin is the output of the error amplifier and
is used for loop compensation.Loop compensation can be implemented
by a simple RC network.
Feedback pin. Sense the output voltage and referenced to 1.276V.
When the voltage at this pin falls below 0.4V,chip
switching-frequency reduces to a much lower frequency.
3
NC
No connection.Keep floating.
Enable pin. A TTL low will shut down the chip and high enable the
4
EN
chip. This pin may also be used to synchronize the part to nearly
twice the base frequency. If synchronization is not used, this pin
should be either tied high or left floating for normal operation.
5
Vcc
Input power supply pin. Supply power to the IC and should have a
bypass capacitor connected to AGND
Analog ground. Provide a clean ground for the controller circuitry
6
AGND and should not be in the path of large currents.This pin is connected
to the IC substrate.
Power ground. This pin is the ground connection for the emitter of
7
PGND the power switching transistor.Connection to a good ground plane is
essential.
High current switch pin. Connect to the collector of the internal
8
Vsw power switch. The open voltage across the power switch can be as
high as 40V. To minimize radiation, use a trace as short as practical.
2/6