73S8010C Datasheet, PDF (1/27 Pages) Teridian Semiconductor Corporation – Smart Card Interface

Simplifying System Integration™
73S8010C
Smart Card Interface
DATA SHEET
April 2009
DESCRIPTION
The Teridian 73S8010C is a single smart card
interface IC. It provides full electrical compliance
with ISO-7816-3 and EMV 4.0 specifications.
Interfacing with the host is done through the two-wire
I2C bus. Data exchange with the card is managed
from the system controller using the I/O line (and
eventually the auxiliary I/O lines).
An on-chip oscillator using an external crystal, or
connection to a clock signal coming from the
system controller can generate the card clock
signal.
The 73S8010C IC incorporates an ISO-7816-3
activation/deactivation sequencer that controls the
card signals. Level shifters drive the card signals
with the selected card voltage (3 V or 5 V), coming
from an internal DC-DC converter.
With its high-efficiency DC-DC converter, the
Teridian 73S8010C is a cost-effective solution for
any smart card reader application to be powered
from a single 2.7 V to 3.6 V power supply.
Hardware support for auxiliary I/O lines, C4 / C8
contacts, is provided.
Emergency card deactivation is initiated upon card
extraction or upon any fault generated by the
protection circuitry. The fault can be a VDD (digital
power supply), a VCC (card power supply), a card
over-current, or an over-heating fault.
ADVANTAGES
• Single smart card interface
• The inductor-based DC-DC converter provides
higher current and efficiency than the usual
charge-pump capacitor-based converters
 Ideal for battery-powered applications
 Suitable for high current cards and
SAMs: (100 mA max)
• Power down mode: 2 µA typical
• Small Format (5x5mm) 32-QFN package option
FEATURES
• Card Interface:
 Complies with ISO-7816-3 and EMV 4.0
 A DC-DC Converter provides 3V / 5V to the
card from an external power supply input
 High-efficiency converter: > 80% @ V_DD= 3.3 V,
V_CC = 5 V and I_CC = 65 mA
 Up to 100 mA supplied to the card
 ISO-7816-3 Activation / Deactivation sequencer
with emergency automated deactivation on
card removal or fault detected by the protection
circuitry
 Protection include 2 voltage supervisors that
detect voltage drops on card V_CC and V_DD
power supplies
 The V_DD voltage supervisor threshold value
can be externally adjusted
 True over-current detection (150 mA max.)
 1 card detection input
 Auxiliary I/O lines, for C4 / C8 contact signals
• Host Interface:
 Fast mode, 400 kbps I²C slave bus
 8 possible devices in parallel
 One control register and one status register
 Interrupt output to the host for fault
detection
 Crystal oscillator or host clock, up to 27 MHz
• Power Supply:
 V_DD: 2.7 V to 3.6 V
• 6 kV ESD Protection on the card interface
• Package: SO28 or 32QFN
APPLICATIONS
• Set-Top-Boxes, DVD / HDD Recorders:
Conditional Access and Pay-per-View slots
• Point of Sales and Transaction Terminals
• EMV slots in cell phones and PDAs
Rev. 1.5
© 2009 Teridian Semiconductor Corporation
1