RV1490D Datasheet, PDF (3/9 Pages) TEMEX – This discrete VCXO offers ultra low RMS phase jitter

Rakon Product Proposal
9.0
Line
9.1
9.2
9.3
9.4
9.5
SSB PHASE NOISE
Parameter
SSB Phase Noise
power density @ 10
Hz offset
SSB Phase Noise
power density @ 100
Hz offset
SSB Phase Noise
power density @ 1
kHz offset
SSB Phase Noise
power density @ 10
kHz offset
SSB Phase Noise
power density @ 100
kHz offset
Test Condition
Value for a 77.76 MHz VCXO @ 25°C
Value for a 77.76 MHz VCXO @ 25°C
Value for a 77.76 MHz VCXO @ 25°C
Value for a 77.76 MHz VCXO @ 25°C
Value for a 77.76 MHz VCXO @ 25°C
Value
-75
-100
-125
-150
-155
Unit
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
-----
10.0
Line
10.1
10.2
10.3
10.4
10.5
10.6
10.7
ENVIRONMENTAL SPECIFICATION
Parameter
Description
SMD
Product suitable for Pb-free convection reflow soldering, compliant with JEDEC standard. J-
STD-020, Level 1.
Storage Temperature
Range
-55 to 125°C
Sealing
Non-hermatic package
Shock
981ms-²(100gn) acceleration for 6ms duration,3 shocks in each direction along 3 mutually
perpendicular axis. IEC 60068-2-27 Test Ea.
Vibration
10-60Hz 0.75mm displacements, 60-500Hz 98.1ms-² (10gn) acceleration. 30 minutes in each
of three mutually perpendicular planes at 1 octave per minute. IEC 60068-2-6 Test Fc
Procedure B4
Marking
Resistant to all common solvents
RoHS
Parts are fully compliant with the European Union Directive 2002/95/EC on the restriction of
the use of certain hazardous substances in electrical and electronic equipment. Note: The
RoHS compliant parts are suitable for assembly using both Lead-free solders and Tin/Lead
solders.
-----
11.0
Line
11.1
11.2
MANUFACTURING INFORMATION
Parameter
Description
Packaging Description Tape and Reel as shown
Reflow
Solder reflow process as per attached profile
-----
12.0
Line
12.1
12.2
12.3
12.4
12.5
12.6
SPECIFICATION NOTES
Parameter
Note 1
Note 2
Note 3
Note 4
Note 5
Note 6
Description
The operating temperature range needs to be specified.
Output current depends on the frequency selected and the output characteristic chosen
Select the exact tuning range required. The values listed are maximum normally available
and may require some trade-off in frequency stability. Standard options are ±50ppm, ±
75ppm, ±100ppm and ±150ppm.
The exact value will be frequency dependant
Enable high or low is available as an option
The jitter values will vary depending on the frequency selected
-------
Page 3