RFPT700 Datasheet, PDF (3/6 Pages) TEMEX – SMD Low Acceleration Sensitivity TCXO / TCVCXO

7.0
Line
7.1
7.2
7.3
7.4
7.5
7.6
7.7
7.8
-----
8.0
Line
8.1
8.2
8.3
8.4
8.5
8.6
-----
9.0
Line
9.1
9.2
-----
10.0
Line
10.1
10.2
10.3
-----
PHASE NOISE
Parameter
SSB phase noise
power density at 1Hz
offset
SSB phase noise
power density at
10Hz offset
SSB phase noise
power density at
100Hz offset
SSB phase noise
power density at 1kHz
offset
SSB phase noise
power density at
10kHz offset
SSB phase noise
power density at
100kHz offset
SSB phase noise
power density at
1MHz offset
Note
Test Condition
Typical value for a 20MHz Clipped sine wave oscillator at 25°C
Typical value for a 20MHz Clipped sine wave oscillator at 25°C
Typical value for a 20MHz Clipped sine wave oscillator at 25°C
Typical value for a 20MHz Clipped sine wave oscillator at 25°C
Typical value for a 20MHz Clipped sine wave oscillator at 25°C
Typical value for a 20MHz Clipped sine wave oscillator at 25°C
Typical value for a 20MHz Clipped sine wave oscillator at 25°C
Low phase noise option available with HCMOS output - consult
sales office
Value
-63
-93
-104
-128
-136
-140
-143
Unit
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
ENVIRONMENTAL INFORMATION
Parameter
Description
Storage temperature -55°C to 125°C
Acceleration Steady
State
IEC 60068-2-7 test Ga, 5000g, 10s (at peak acceleration), Y-axis only
Vibration
IEC 60068-2-6, test Fc: 10-60Hz 0.75mm displacement, 60-500Hz 200m/s^2 (20gn)
acceleration, 1.5 hours in each of three mutually perpendicular axes at 1 octave per minute.
Mechanical Shock
IEC 60068-2-27, test Ea; 1000 m/s^2 (100gn) acceleration for 6ms, half sine pulse, 3 shocks
in each direction along three mutually perpendicular axes (18 shocks total)
RoHS
Parts are fully compliant with the European Union directive 2002/95/EC on the restriction of
the use of certain hazardous substances in electrical and electronic equipment. Note parts are
suitable for assembly using both Lead-free solders and Tin/Lead solders. Non-RoHS version
available on request.
Marking
Laser Marked
MANUFACTURING INFORMATION
Parameter
Description
Reflow Soldering
See reflow profile diagram. Solderability: MIL-STD-202, method 208, category 3
Packaging description Quantities ≥ 100 pieces will be supplied on tape & reel
SPECIFICATION NOTES
Parameter
Note 1
Note 2
Note 3
Description
Availability of stability depends on temperature range - not all combinations may be possible -
please check with our sales office.
Availability of temperature range -55 to 105°C depends on nominal frequency - please check
with our sales office.
ACMOS / pure sine wave output available upon request
Page 3