RFPT500 Datasheet, PDF (2/5 Pages) TEMEX – SMD Temperature Compensated Crystal Oscillator

-----
5.0
Line
5.1
5.2
5.3
5.4
5.5
5.6
-----
6.0
Line
6.1
6.2
6.3
6.4
6.5
6.6
-----
7.0
Line
7.1
7.2
7.3
7.4
7.5
7.6
-----
8.0
Line
8.1
8.2
8.3
-----
OSCILLATOR OUTPUT- HCMOS
Parameter
Test Condition
Output waveform
HCMOS (other types available upon request)
Output voltage low
level
Output voltage high
level
Output load
Nominal load 15pF
Duty cycle
At 50%
Rise and fall time
tr, tf (for 3.3V HCMOS ouput with 15pF load). 10 to 90%
Value
0.1 max
0.9 min
10 to 20
45 to 55
8 max
Unit
Vs
Vs
pF
%
ns
SSB PHASE NOISE
Parameter
SSB phase noise
power density at 1Hz
offset
SSB phase noise
power density at
10Hz offset
SSB phase noise
power density at
100Hz offset
SSB phase noise
power density at 1kHz
offset
SSB phase noise
power density at
10kHz offset
SSB phase noise
power density at
100kHz offset
Test Condition
Typical values for a 12.8MHz oscillator at 25°C
Typical values for a 12.8MHz oscillator at 25°C
Typical values for a 12.8MHz oscillator at 25°C
Typical values for a 12.8MHz oscillator at 25°C
Typical values for a 12.8MHz oscillator at 25°C
Typical values for a 12.8MHz oscillator at 25°C
Value
-65
-95
-120
-130
-140
-145
Unit
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
ENVIRONMENTAL
Parameter
Vibration
Shock
Soldering
RoHS
Storage temperature
range
Humidity
Description
IEC 60068-2-6, test Fc, 10-60Hz 1.5mm displacement, 60-2000Hz at 10gn, 30 minutes in
each of three mutually perpendicular axes at 1 octave per minute
IEC 60068-2-27, test Ea: 1500gn acceleration for 0.5ms duration, half-sine pulse, 3 shocks in
each direction along three mutually perpendicular axes
SMD product suitable for reflow soldering. Peak temperature 260°C. Maximum time above 220
°C, 60s
Parts are fully compliant with the European Union directive 2002/95/EC on the restriction of
the use of certain hazardous substances in electrical and electronic equipment. Note these
RoHS compliant parts are suitable for assembly using both lead-free solders and tin/lead
solders
-55 to 125°C
85% for 48 hours at 85°C, non-condensing
MARKING
Parameter
Type
Line 1
Line 2
Description
Laser marked
R and manufacturing identifier (XXX) (refer to model drawing)
Pad 1 / static sensitivity identifier (Δ), abbreviated part number (0000), device date code
(YW) (refer to model drawing)
Page 2