RPT5032A Datasheet, PDF (1/2 Pages) TEMEX – Best in class frequency versus temperature

PLUTO+ ™ ULTRA STABLE SMD TCXO
RPT5032A
The RPT5032A encompasses Rakon's new patented Pluto+ ASIC. Pluto+ advances on the world famous, ‘best‐in‐class’ Pluto ASIC
technology by delivering exceptional phase noise and jitter performance, and enhanced frequency versus temperature stability. The single
chip oscillator with its analogue compensation circuit is capable of sub 0.1ppm frequency stability over an extended temperature range and
RMS phase jitter down to 0.13ps for IEEE1588 and SyncE applications. It’s unique tilt control ensures lifetime specification compliance, unlike
other TCXOs available.
Features
 Best in class frequency versus temperature
 RMS phase jitter down to 0.13ps
 Phase noise < ‐160dBc/Hz noise floor
 Voltage control and T‐sense options available
Applications
 Time and frequency reference
o Positioning
o Test and Measurement
o Telecommunications
o Hi‐Rel / Defense
5.0 x 3.2 mm
Standard Specifications
Parameter
Nominal frequency
Frequency calibration
Reflow shift
Operating temperature range
Frequency stability
over temperature
Supply voltage stability
Load sensitivity
Long term stability (aging)
≤26MHz
>26MHz
Acceleration Stability
Start‐up time
Supply voltage, V_CC
Current (C/Sine)
Current (Sine)
Current (HCMOS)
Current (ACMOS)
Control voltage, Vc
Frequency tuning
≤26MHz
>26MHz
Root Allan Variance (20MHz)
Oscillator output options
Tri‐State Control
Input level low (pin 6)
Input level high (pin 6)
Min. Typ.
Max. Unit
1.25 –
MHz
52
±1
ppm
±0.5
ppm
‐55
105
°C
±0.05 – ppm
±2.5
±0.025
ppm
±0.05
ppm
Test Condition / Description
Standard frequencies: 10.0, 12.8, 16.384, 19.2,
19.44, 20.0, 25.0, 26.0, 30.72, 38.88 and 40MHz
Initial accuracy at 25 ± 1°C
Pre to post reflow ΔF (measured ≥ 60 minutes
after reflow)
Reference to (Fmax + Fmin)/2. The best available
stability depends on the nominal frequency and
selected operating temperature range
±5% variation
Reference to frequency at nominal V_CC
 HCMOS, ACMOS: ±5pF variation,
 Clipped sine wave / Sine wave: ±10% variation
reference to frequency at nominal load
<2
2.5
2
8
4
8
0.5
±1
±2
5 – 15
5.7
2.5
ppm/year
ppm/year
ppb/g
ms
V
mA
mA
mA
mA
V
±3ppm/10 years
±5ppm/10 years
Gamma vector, 3‐axes, 30‐1500Hz
90% amplitude
±5%, standard values are 3.0, 3.3 and 5.0V
±5
±7
5
ppm
ppm
10^‐11
tau = 1.0s
Clipped sine wave, sine wave, HCMOS (LVCMOS
& LVTTL compatible as per JESD8C) and ACMOS
0.6V_CC
0.2V_CC
V
V
Device disabled, output in high impedance state
Device enabled, operating
www.rakon.com
[e-mail]
Page 1 of 2