AC2327 Datasheet, PDF (1/2 Pages) Teledyne Technologies Incorporated – TO-8 CASCADABLE AMPLIFIER

Rev. 5/10
AC2327
1 TO 2300 MHz
TO-8 CASCADABLE AMPLIFIER
Typical Values
Low Frequency . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Medium Output Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Performance Thin Film
Standard Size TO-8
AC2327
1 MHz
+13.5 dBm
AC2327
TO-8 Package for Amplifiers
SPECIFICATIONS^*
Parameter
Frequency (Min.)
Small Signal Gain (Min.)
Gain Flatness (Max.)
Noise Figure (Max.)
10-1000
1000-2500
SWR (Max.)
Input/Output
Typical
1-2300 MHz
8.0 dB
±0.4 dB
5.5 dB
7.0 dB
<1.9:1
Power Output (Min.)
@ 1dB comp.
+13.5 dBm
DC Current (Max.)
44 mA
Guaranteed
0 to 50 °C -55 to +85 °C
1-2300 MHz
1-2300 MHz
7.5 dB
7.0 dB
±0.7 dB
±1.0 dB
6.0 dB
8.5 dB
2.2:1
6.5 dB
9.0 dB
2.4:1
+12.5 dBm
48 mA
+12.0 dBm
52 mA
* Measured in a 50-ohm system at +15 Vdc unless otherwise specified.
INTERMODULATION PERFORMANCE
Typical @ 25 °C; 1000 MHz
Second Order Harmonic Intercept Point. . . . . . . . . . . . . . .
Second Order Two Tone Intercept Point . . . . . . . . . . . . . . .
Third Order Two Tone Intercept Point . . . . . . . . . . . . . . . . .
AC2327
+43 dBm
+37 dBm
+27.5 dBm
AS2327
SMTO-8 Package for Amplifiers
ABSOLUTE MAXIMUM RATINGS
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -62 to +125 °C
Maximum Case Temperature . . . . . . . . . . . . . . . . . . . . . . . .
+125 °C
Maximum DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+17 Volts
Maximum Continuous RF Input Power . . . . . . . . . . . . . . . .
+13 dBm
Maximum Short Term Input Power (1 Minute Max.) . . . . . . . 50 Milliwatts
Maximum Peak Power (3 µsec Max.) . . . . . . . . . . . . . . . . . .
0.5 Watt
Burn-in Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+105 °C
Thermal Resistance¹ (θjc) . . . . . . . . . . . . . . . . . . . . . . . . . . +60 °C/Watt
Junction Temperature Rise Above Case (Tjc) . . . . . . . . . . .
+42 °C
1 _{Thermal resistance is based on total power dissipation.}
If DC is present on RF input/output, this model
requires additional external blocking capacitors.
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: [phone] • Updates: www.teledynemicrowave.com • [e-mail]