J431-5PM Datasheet, PDF (3/6 Pages) Teledyne Technologies Incorporated – ESTABLISHED RELIABILITY TO-5 RELAYS

SERIES 431
OUTLINE DIMENSIONS
CASE DETAIL
.370
(9.40)
DIA. MAX.
.335
(8.51)
DIA. MAX.
.035 (.89)
± .010 (0.25)
LEAD & PIN LOCATIONS
(Viewed from Terminals)
.031 (.79)
± .003 (0.08)
.200 (5.08)
± .010 (.25) DIA.
PIN NUMBERS
(For reference only)
9
1
8
2
7
3
6
4
431T
.375 (9.52) MAX.
WIRE LEAD: .75 (19.05) MIN.
PIN: .187 (4.75) ± . 010 (.25)
(See Note 6)
+.002(.05)
.017(.43) _{±.001(.03)} DIA.
45° ±3°
TYP.
5 LEADS
431, 431D, 431DD
36° ±3°
TYP.
4
8 LEADS
3
431T
DIMENSIONS ARE SHOWN IN INCHES (MILLIMETERS)
1
5
2
431
SCHEMATIC DIAGRAMS
431
431DD
431T
431D
SCHEMATICS ARE VIEWED FROM TERMINALS
GENERAL NOTES
1. Relay contacts will exhibit no chatter in excess of 10 μsec or transfer in excess
of 1 μsec.
2. “Typical” characteristics are based on available data and are best estimates. No
on-going verification tests are performed.
3. Unless otherwise specified, parameters are initial values.
4. For reference only. Coil resistance not directly measurable at relay terminals due
to internal series semiconductor. 431DD and 431T only.
5. Unless otherwise specified, relays will be supplied with either gold-plated or
solder-coated leads.
6. The slash and characters appearing after the slash are not marked on the relay.
7. Limit Base Emitter current to 15 mAdc.
8. Applicable to all coil voltages. See Base current to turn on.
9. Screened HI-REL versions available. Contact factory.
10.
TYPICAL LOGIC INTERFACE
(See Note 8)
Vcc
Vr
Pin 1
Logic element
1 = 0.20 to 1.20mA
0 = 0.3Vdc min.
Pin 4
Pin 2
Pin 3
Notes:
Logic 1 activates the relay.
Logic 0 de-activates the relay.
Vcc = logic bias power.
Vr = coil energization voltage.
Established Reliability
Designator
Relay Series
Optional Ground Pin
(See Appendix)
Pad Option
(See Appendix)
Teledyne Part Numbering System for T²R^® Established Reliability Relay
ER 431 Y M3 - 26 A / S Q
Q= Solder Coated Leads
G= Gold Plated Leads
(Notes 5 and 6)
S= .187" leads
(Note 6)
Screening and Reliability
Level
Coil Voltage
Military (JAN)
Designator
Relay Series
Pad Option
(See Appendix)
Teledyne Part Numbering System for Military Qualified (JAN) Relays
J 431 M3 - 26 P L
Screening and Reliability
Level
Terminal Variant
P = 0.187"
Coil Voltage
431 Page 3
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
www.teledynerelays.com
©2003 TELEDYNE RELAYS
431/1203/Q1