712DM2-26 Datasheet, PDF (3/6 Pages) Teledyne Technologies Incorporated – COMMERCIAL TO-5 RELAYS DPDT

SERIES 712
OUTLINE DIMENSIONS
CASE DETAIL
.370
(9.40)
DIA. MAX.
.335
(8.51)
DIA. MAX.
TERMINAL LOCATIONS AND PIN NUMBERING (REF. ONLY)
(Viewed from Terminals)
.031 (.79)
± .003 (0.08)
.035 (.89)
± .010 (0.25)
TRANSISTOR BASE
10
CONNECTION FOR
712TN ONLY
9
1
8
2
.275 (6.99) MAX.
.200 (5.08)
± .010 (.25) DIA.
WIRE LEAD: .75 (19.05) MIN.
36° ±3°
TYP.
7
3
6 ₅₄
+.002 (.05)
.017 (.43) _{–.001 (.03)} DIA.
DIMENSIONS ARE SHOWN IN INCHES (MILLIMETERS)
SCHEMATIC DIAGRAM
712
712D
712TN
SCHEMATICS ARE VIEWED FROM TERMINALS
GENERAL NOTES
1. Relay contacts will exhibit no chatter in excess of 10 µsec or transfer in excess of
1 µsec.
2. “Typical” characteristics are based on available data and are best estimates. No
on-going verification tests are performed.
3. Unless otherwise specified, parameters are initial values.
4. For Reference Only. Coil resistance not directly measurable on 712TN relays.
5. Circuit is typical for all Series 712TN. Values shown are for 712TN-5 relay and
apply for full temperature range. Limit base-emitter current to 15 mADC
6. The slash and characters appearing after the slash are not marked on the relay.
7. Unless otherwise specified, relays will be supplied with either gold-plated or
solder-coated leads.
8.
TYPICAL LOGIC INTERFACE
(See Note 5)
Vcc
Vr
Pin 1
Logic element
1 = 0.50 to 3.00mA
0 = 0.3Vdc min.
Pin 10
Pin 9
Notes:
Logic 1 activates the relay.
Logic 0 de-activates the relay.
Vcc = logic bias power.
Vr = coil energization voltage.
Teledyne Part Numbering System for Commercial Relays
712 X M - 26 / S Q
Relay Series
Optional Ground Pin
(See Appendix )
Pad Option
(See Appendix)
Q= Solder Coated Leads
G= Gold Plated Leads
(Notes 6 and 7)
S= 0.187" leads
(Note 6)
Coil Voltage
712 Page 95
SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE
www.teledynerelays.com
©2009 TELEDYNE RELAYS
712/0909/Q3