DAQ6116 Datasheet, PDF (1/2 Pages) Teledyne Technologies Incorporated – 0.1 TO 6.0 GHz PEAK TO PEAK ANALOG DETECTOR

Rev. 5/10
DAQ6116
0.1 TO 6.0 GHz
PEAK TO PEAK ANALOG DETECTOR
Typical Values @ +25 °C
DAQ6116
Wide Frequency Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . 0.05 to 8.0 GHz
Wide Power Range . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . –5.0 to +25.0 dBm
Temperature Stability . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
± 0.5 dB
Flatness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
± 0.5 dB
Low VSWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
1.5:1
Even Order Harmonics Supression. . . . . . . . . . . . . . . . . . .
40 dB
No Power Supply Required / Zero Bias
Cougar Q Package or Standard SMTO-8 package
SPECIFICATIONS^*
Parameter
Typical
Frequency (Min.)
0.05-8.0 GHz
Input Power Range (Min.)
VSWR (Max.)
Sensitivity, Vout (Min.)
Power Flatness (Max.)
Temperature Stability (Max.)
Pulse Response, Pin > +10 dBm
Pulse Response, Pin = 0 to +10 dBm
-5 to +25 dBm
1.5:1
180 mV†
±0.5 dB
—
360 µsec‡
380 µsec‡
Guaranteed
0 to 50 °C -55 to +85 °C
0.1-6.0 GHz
0.1-6.0 GHz
0 to +20 dBm
2.0:1
120 mV†
±0.75 dB
±0.5 dB^
25/500 µsec‡
500/500 µsec‡
0 to +20 dBm
2.0:1
90 mV†
±0.75 dB
±0.5 dB^
25/500 µsec‡
500/500 µsec‡
DAQ6116
SM-25 for Detectors
* Measured in a 50-Ohm system and R load = 1 MOhm unless otherwise specified.
† Pin = 0 dBm. ^ Vout = 1.0 V. ‡ Tr/Tf, 50% RF to 90% or 10% Video, Rload = 80 KOhms.
MAXIMUM RATINGS
DAS6116
SMTO-8 Package for Detectors
Continuous RF Input Power . . . . . . . . . . . . . . . . . . . . .
+25.0 dBm
Operating Case Temperature . . . . . . . . . . . . . . . . . . . . -55 °C to +150 °C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . -65 °C to +150 °C
Burn-In Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . .
+125 °C
Detector Thermal Resistance¹ (θjc) . . . . . . . . . . . . . . .
+1000 °C/Watt
Temperature Rise @ 20 dBm (Tjc) . . . . . . . . . . . . . . . .
+4 °C
Temperature Rise @ 25 dBm (Tjc) . . . . . . . . . . . . . . . .
+68 °C
1 _{Thermal resistance is based on total power dissipation. Ratings based on +25 °C.}
APPLICATION NOTES
DAQ6116 is configured using two anti-parallel connected schottky diodes to form an
unbiased peak to peak microwave detector with a differential output voltage.
The harmonic distortion reflected back to the system can be significantly lower than single
ended design because all even order harmonics are suppressed, typically > 40 dB.
The output voltage (differential) is a closer representation of the true rms power of
modulated or distorted signals because both positive and negative waveform peaks are
detected.
The DAQ6116 is intended for higher level detection applications (> 0 dBm) requiring good
temperature stability and harmonic suppression.
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: [phone] • Updates: www.teledynemicrowave.com • [e-mail]