DAQ6101 Datasheet, PDF (1/2 Pages) Teledyne Technologies Incorporated – 0.1 TO 6.0 GHz ANALOG DETECTOR

Rev. 7/10
DAQ6101
0.1 TO 6.0 GHz
ANALOG DETECTOR
Typical Values @ +25 °C
Wide Frequency Range. . . . . . . . . . . . . . . . . . . . . . . . .
Wide Power Range . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Temperature Stability . . . . . . . . . . . . . . . . . . . . . . . . . .
Flatness . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low VSWR . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Single or Dual Power Supply
Cougar Q Package
DAQ6101
0.1 to 8.0 GHz
–30.0 to +5.0 dBm
± 0.25 dB
± 0.5 dB
1.5:1
DAQ6101
SM-25 for Detectors
SPECIFICATIONS^*
Parameter
Frequency (Min.)
Input Power Range (Min.)
VSWR (Max.)
Sensitivity, Vout (Min.)
Power Flatness (Max.)
Temperature Stability (Max.)
Output Offset Voltage,
no RF (Max.)
1 dB Square Law Departure
Tangential Sensitivity
Pulse Response, Pin = -15 dBm
Pulse Response, Pin = 0 dBm
Supply Current, no RF
Supply Current, Pin = +5 dBm
Typical
0.1-8.0 GHz
-30 to +5 dBm
1.5:1†
120 mV†
±0.5 dB^
±0.25 dB†
±0.5 mV
-10 dBm
-45 dBm^^
1.5 µsec‡
3.0 µsec‡
2 +mA, 2 -mA
10 +mA, 2 -mA
Guaranteed
0 to 50 °C -55 to +85 °C
0.1-6.0 GHz
0.1-6.0 GHz
-25 to 0 dBm
2.0:1†
90 mV†
±0.75 dB^
±0.5 dB†
-25 to 0 dBm
2.0:1†
90 mV†
±0.75 dB^
±0.5 dB†
±2.0 mV
—
—
—
—
—
±2.0 mV
—
—
—
—
—
* Measured in a 50-Ohm system at ±5 Vdc, 2 KΩ||50 pF unless otherwise specified.
† Pin = –15 dBm. ^ Vout = 100 mV. ^^ 3 dB NF, 1 MHz Bandwidth. ‡ 50% RF to 10 or 90% Video.
DAS6101
SMTO-8 Package for Detectors
MAXIMUM RATINGS
DC Voltage (no RF) . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
±18 V
Continuous RF Input Power . . . . . . . . . . . . . . . . . . . . . +14.0 dBm (±5 Vdc)
Operating Case Temperature . . . . . . . . . . . . . . . . . . . . -55 °C to +100 °C
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . -65 °C to +125 °C
Burn-In Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . .
+100 °C
Detector Thermal Resistance¹ (θjc) . . . . . . . . . . . . . . .
+3500 °C/Watt
Temperature Rise @ 0 dBm (Tjc) . . . . . . . . . . . . . . . . .
+3.5 °C
Temperature Rise @ +5 dBm (Tjc) . . . . . . . . . . . . . . . .
+35 °C
1 _{Thermal resistance is based on RF input power. Ratings based on +25 °C.}
APPLICATION NOTES
This unit is DC coupled and employs a RF choke at the input (DC short). If the application
calls for the input to sink current there will approximately be an additional 1 mV of output
offset voltage for each 3 mA of current. Sink current should be limited to 100 mA max to
avoid choke burnout.
For higher supply voltages, up to ±15 volts, the positive supply pin must include a series
current limiting resistor, Rs = (Vs – 5)/0.01. (e.g.: Vs = 15v, Rs = 1K)
Average power detection is obtained at power levels below approximately –13 dBm.
For best pulse response both supply pins should be bypassed with an additional
1.0 µF capacitor. The unit contains 0.01 µF internal capacitors.
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: [phone] • Updates: www.teledynemicrowave.com • [e-mail]