A2P2010 Datasheet, PDF (1/1 Pages) Teledyne Technologies Incorporated – SMA CASCADED AMPLIFIER

PRELIMINARY
A2P2010
30 TO 2000 MHz
SMA CASCADED AMPLIFIER
Typical Values
High Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low Noise Figure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Output Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Third Order I.P. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Reverse Isolation . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Performance Thin Film
Power Pack SMA Package
A2P2010
19.2 dB
5.0 dB
+29.5 dBm
+40 dBm
37 dB
A2P2010
Power Pack SMA Case
(two-stage)
SPECIFICATIONS^*
Parameter
Frequency (Min.)
Small Signal Gain (Min.)
Typical
20-2100 MHz
19.2 dB
Gain Flatness (Max.)
±0.5 dB
Noise Figure (Max.)
5.0^ dB
SWR (Max.)
Input/Output
1.7:1
Power Output (Min.)
@ 1dB comp.
+29.5† dBm
Reverse Isolation
37 dB
DC Current (Max.)
555 mA
Guaranteed
0 to 50 °C -55 to +85 °C
30-2000 MHz
30-2000 MHz
17.5 dB
16.5 dB
±0.7 dB
±0.8 dB
7.0^ dB
7.5^ dB
1.9:1
2.0:1
+29.0† dBm
—
585 mA
+28.5† dBm
—
600 mA
* Measured in a 50-ohm system at +15 Vdc unless otherwise specified.
^ 1.0 dB higher between 100-200 MHz and at 2000 MHz.
† 1.0 dBm lower below 900 MHz. Indicates minimum temperature at -55/+71 °C.
INTERMODULATION PERFORMANCE
Typical @ 25 °C
Second Order Harmonic Intercept Point. . . . . . . . . . . . . . .
Second Order Two Tone Intercept Point . . . . . . . . . . . . . . .
Third Order Two Tone Intercept Point . . . . . . . . . . . . . . . . .
A2P2010
+61 dBm
+55 dBm
+40 dBm
ABSOLUTE MAXIMUM RATINGS
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -62 to +125 °C
Maximum Case Temperature . . . . . . . . . . . . . . . . . . . . . . . .
+105 °C
Maximum DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+17 Volts
Maximum Continuous RF Input Power . . . . . . . . . . . . . . . .
+13 dBm¹
Maximum Short Term Input Power (1 Minute Max.) . . . . . . . 200 Milliwatts
Maximum Peak Power (3 µsec Max.) . . . . . . . . . . . . . . . . . .
0.5 Watt
Burn-in Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+85 °C
Thermal Resistance² (θjc) . . . . . . . . . . . . . . . . . . . . . . . . . . +24 °C/Watt
Junction Temperature Rise Above Case (Tjc) . . . . . . . . . . .
+69.5 °C
1 _{If no load on output; decrease input power (no damage) by 10 dBm.}
2 _{Thermal resistance is based on total power dissipation.}
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: [phone] • Updates: www.teledynemicrowave.com • [e-mail]