A2P1220 Datasheet, PDF (1/1 Pages) Teledyne Technologies Incorporated – SMA CASCADED AMPLIFIER

PRELIMINARY
A2P1220
30 TO 1200 MHz
SMA CASCADED AMPLIFIER
Typical Values
High Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Low Noise Figure . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Output Level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Third Order I.P. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Reverse Isolation . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Performance Thin Film
Power Pack SMA Package
A2P1220
31.5 dB
4.3 dB
+29.7 dBm
+40 dBm
53 dB
SPECIFICATIONS^*
Parameter
Frequency (Min.)
Small Signal Gain (Min.)
Typical
20-1200 MHz
31.5 dB
Gain Flatness (Max.)
±0.5 dB
Noise Figure (Max.)
4.3 dB
SWR (Max.)
Input/Output
30-500 MHz
500-1200 MHz
1.8:1
1.6:1
Guaranteed
0 to 50 °C -55 to +85 °C
30-1200 MHz
29.0 dB
30-1200 MHz
27.5 dB
±0.7 dB
±1.0 dB
5.5 dB
6.0 dB
1.9:1
1.8:1
2.1:1
2.0:1
Power Output (Min.)
@ 1dB comp.
Reverse Isolation
DC Current (Max.)
+29.7 dBm
53 dB
500 mA
+29.0 dBm
—
520 mA
+28.5† dBm
—
530 mA
* Measured in a 50-ohm system at +15 Vdc unless otherwise specified.
† Indicates minimum temperature at -55/+71 °C.
INTERMODULATION PERFORMANCE
Typical @ 25 °C
Second Order Harmonic Intercept Point. . . . . . . . . . . . . . .
Second Order Two Tone Intercept Point . . . . . . . . . . . . . . .
Third Order Two Tone Intercept Point . . . . . . . . . . . . . . . . .
A2P1220
+59 dBm
+53 dBm
+40 dBm
A2P1220
Power Pack SMA Case
(two-stage)
ABSOLUTE MAXIMUM RATINGS
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -62 to +125 °C
Maximum Case Temperature . . . . . . . . . . . . . . . . . . . . . . . .
+110 °C
Maximum DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+17 Volts
Maximum Continuous RF Input Power . . . . . . . . . . . . . . . .
0 dBm¹
Maximum Short Term Input Power (1 Minute Max.) . . . . . . . 50 Milliwatts
Maximum Peak Power (3 µsec Max.) . . . . . . . . . . . . . . . . . .
0.5 Watt
Burn-in Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+85 °C
Thermal Resistance² (θjc) . . . . . . . . . . . . . . . . . . . . . . . . . . +10 °C/Watt
Junction Temperature Rise Above Case (Tjc) . . . . . . . . . . .
+57.8 °C
1 _{If no load on output; decrease input power (no damage) by 10 dBm.}
2 _{Thermal resistance is based on total power dissipation.}
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: [phone] • Updates: www.teledynemicrowave.com • [e-mail]