A2CP2596 Datasheet, PDF (1/4 Pages) Teledyne Technologies Incorporated – 20 TO 2500 MHz, 3 WATTS COUGARPAK™ AMPLIFIER

Rev. 5/10
A2CP2596
20 TO 2500 MHz, 3 WATTS
COUGARPAK™ AMPLIFIER
Typical Values
High Gain . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
High Output Power, P1dB . . . . . . . . . . . . . . . . . . . . . . . . . .
High Saturated Power, Psat. . . . . . . . . . . . . . . . . . . . . . . . .
High Third Order I.P. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Thin Film Two-stage CougarPak™
A2CP2596
+23.5 dB
3.0 Watts
6.0 Watts
+45 dBm
A2CP2596
Two-stage High Power
CougarPak™ SMA Package
SPECIFICATIONS^*
Parameter
Frequency (Min.)
Small Signal Gain^ (Min.)
Gain Flatness (Max.)
Noise Figure (Max.)
100-300 MHz
300-2500 MHz
SWR (Max.)
Input/Output
Power Output (Min.)
@ 1dB comp. 20-500 MHz
500-2500 MHz
Reverse Isolation
DC Current (Max.)
1st Stg: +15V
Linear Oper. 2nd Stg: +28V
Psat w/+20 dBm Input
2nd Stage: +28V
Typical
10-2600 MHz
23.5 dB
±0.6 dB
4.8 dB
4.3 dB
<1.8:1
+36.5 dBm
+34.5 dBm
37.0 dB
335 mA
530 mA
700 mA
Guaranteed
0 to 50 °C -55 to +85 °C
20-2500 MHz
20-2500 MHz
22.0 dB
±0.8 dB
21.0 dB
±1.0 dB
5.5 dB
5.0 dB
2.0:1
8.0 dB
5.5 dB
2.0:1
+36.0 dBm
+34.0 dBm
—
+35.0 dBm
+34.0 dBm
—
350 mA
560 mA
750 mA
360 mA
580 mA
760 mA
* Measured in a 50-ohm system at +15/+28V. ^ 0.5 dB less under 50 MHz.
INTERMODULATION PERFORMANCE
Typical @ 25 °C
Second Order Harmonic Intercept Point . . . . . . . . . . . . . .
Second Order Two Tone Intercept Point . . . . . . . . . . . . . . .
Third Order Two Tone Intercept Point . . . . . . . . . . . . . . . . .
A2CP2596
+51 dBm
+46 dBm
+45 dBm
Pin V1: +15V
Pin V2: +28V
HEAT SINK WARNING:
This amplifier requires an adequate heat sink
to prevent damage. Maximum case tempera-
ture must not be exceeded. The package is
designed to provide adequate heat transfer
to proper aluminum heat sink.
ABSOLUTE MAXIMUM RATINGS
Storage Temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . -62 to +125 °C
Maximum Case Temperature, +28V/+32V . . . . . . . . . . . . . . +90 °C/+75 °C
Maximum DC Voltage . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
+33 Volts
Maximum Continuous RF Input Power . . . . . . . . . . . . . . . .
+20 dBm¹
Maximum Short Term Input Power (1 Minute Max.) . . . . . .
+22 dBm
Maximum Peak Power (3 µsec Max.) . . . . . . . . . . . . . . . . . .
+24 dBm
Burn-in Temperature, +28V . . . . . . . . . . . . . . . . . . . . . . . . .
+85 °C
Thermal Resistance² (θjc) . . . . . . . . . . . . . . . . . . . . . . . . . . +4.3 °C/Watt
Junction Temperature Rise Above Case (Tjc), +28V . . . . .
+83 °C
1 _{If no load or a short on output; decrease input power by +10 dBm.}
2 _{Thermal resistance is based on total power dissipation.}
DIMENSIONS ARE IN INCHES [MILLIMETERS]
650-691-9800 • Fax: [phone] • Updates: www.teledynemicrowave.com • [e-mail]