408-9930 Datasheet, PDF (4/4 Pages) TE Connectivity Ltd – PRO-CRIMPER* III Hand Crimping

408-9930
5. MAINTENANCE AND INSPECTION
5.1. Initial Inspection
PRO-CRIMPER III Hand Crimping Tool Frame Assembly 354940-1 is inspected prior to shipment. It is
recommended that it be inspected upon arrival to ensure that it has not become damaged during shipping.
5.2. Daily Maintenance
It is recommended that operators of the tool be made aware of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and any other contaminants from the tool with a clean, soft brush, or a clean,
soft, lint-free cloth. Do NOT use hard or abrasive objects that could damage the tool.
2. Make certain that the pivot pins are in place and that they are secured with retaining rings.
3. All pins, pivot points, and bearing surfaces should be protected with a thin coat of any good SAE 20
motor oil. Do not oil excessively.
4. When the tool is not in use, keep handles closed to prevent objects from becoming lodged in the jaws.
Store the tool in a clean, dry area.
5.3. Periodic Inspection
Regular inspections of the tool should be performed by quality control personnel. A record of scheduled
inspections should remain with the tool or be supplied to personnel responsible for the tool. Inspection
frequency should be based upon amount of use, working conditions, operator training and skill, and established
company standards.
1. Remove all lubrication and accumulated film by immersing the tool (handles partially closed) in a
suitable commercial degreaser that will not affect paint or plastic material.
2. Make certain that all pivot pins are in place and secured with retaining rings.
3. Close the tool handles until the ratchet releases and then allow them to open freely. If they do not
open quickly and fully, the spring is defective and must be replaced. See Paragraph 6,
REPLACEMENT AND REPAIR.
4. Inspect the tool frame for wear or damage, paying particular attention to the jaws and pivot points. If
damage is evident, refer to Paragraph 6, REPLACEMENT AND REPAIR. If tool is acceptable,
lubricate it, and return it to service.
6. REPLACEMENT AND REPAIR
Order a new tool frame or die assembly through your TE Representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
7. REVISION SUMMARY
 Updated document to corporate requirements
 Changed amount of “clicks” in Paragraphs 3.1.4 and 3.2.5 and NOTEs in Paragraphs 3.1.4 and 3.2.5.
Rev G
4 of 4