408-9357 Datasheet, PDF (4/5 Pages) TE Connectivity Ltd – PRO-CRIMPER* III Hand Crimping

408- 9357
Position Point
on Center of
Wire Barrel
Opposite
Seam
Spindle
Modified
Anvil
Crimp
Height
Wire Size (AWG)
(Max)
24
20
Crimp Height Dimension
+0.05 mm [+.002 in.]
0.724 [.0285]
0.749 [.0295]
Figure 4
6. RATCHET (Crimp Height) ADJUSTMENT (Figure 5)
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel
from the locator side of the tool.
3. Observe the ratchet adjustment wheel. If a
tighter crimp is required, rotate the adjustment
wheel counterclockwise to a higher--numbered
setting. If a looser crimp is required, rotate the
adjustment wheel clockwise to a lower--numbered
setting.
4. Re--assemble the lockscrew.
5. Make a sample crimp and measure the crimp
height.
6. If the dimension is unacceptable, continue to
adjust the ratchet, and again measure a sample
crimp.
7. MAINTENANCE
Ensure that the tool and dies are clean by wiping
them with a clean, soft cloth. Remove any debris with
a clean, soft brush. Do not use objects that could
damage the tool. When not in use, keep handles
closed to prevent objects from becoming lodged in
the crimping dies, and store in a clean, dry area.
8. VISUAL INSPECTION
The crimping dies should be inspected on a regular
basis to ensure that they have not become worn or
damaged. Inspect the crimping chambers for
flattened, chipped, worn, or broken areas. If damage
or abnormal wear is evident, the tool must be
replaced. See Section 9, REPLACEMENT.
9. REPLACEMENT
Customer--replaceable parts are shown in Figure 1.
Available separately, PRO--CRIMPER III Hand
Crimping Tool Repair Kit 679221--1 includes a
replacement nut and a variety of pins, rings, screws,
and springs.
If the dies are damaged or worn excessively, they
must be replaced.
Order repair kit and replaceable parts through your
TE representative, or call 1--800--526--5142, or send a
facsimile of your purchase order to 717--986--7605, or
write to:
CUSTOMER SERVICE (38--35)
TYCO ELECTRONICS
PO BOX 3608
HARRISBURG PA 17105--3608
Screwdriver
Ratchet Adjustment
Wheel
Lockscrew
(Typ)
Figure 5
10. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements.
4 of 5
Rev E