408-8783 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – Solder Assembly Kit

408-8783
For 2.16
[.085] Cable
For 3.58
[.141] Cable
For 1.78
[.070] Cable
Figure 4
5. USING SOLDER GAGES AND CENTER CONTACT
HOLDER
The center contact holder is designed to hold both
male and female connector center contacts.
Solder gages are used to properly space the center
contact away from the cable dielectric. Refer to the
connector specific instruction sheet for the appropriate
solder gage to be used during the assembly
procedure.
CAUTION
Center contact holders contains small amounts of
lead. The lead is used for assembly.
!
NOTE
i
Maximum operating temperature for the center
contact holder is 300°C [572°F]
DANGER
STOP
To avoid personal injury, be sure to observe all local
safety practices (including the use of gloves). The
solder gage, center contact holder, and the contact
may be hot after soldering.
6. USING LOCATING TOOLS
Solder Assembly Kit 1055469-1 contains two locating
tools. Refer to the connector specific instruction sheet
for selection of proper locator tool and assembly
instructions.
These tools are designed to be used with the fixture
subassembly. To insure proper connector assembly,
follow the instructions listed below.
1. Place connector housing on end of cable sub-
assembly. The subassembly refers to cable with
center contact.
2. Place loose connector assembly in fixture base.
3. Nest the center contact in locator tool.
4. Tighten the thumbscrew to secure the cable.
5. Tighten the locator tool to seat the cable firmly.
6. Slide connector housing over locator tool.
7. Maintain position of housing firmly against locator
tool.
DANGER
To avoid personal injury, be sure to follow all local
safety practices when using solder and solder
STOP
equipment.
8. Solder according to the connector specific
instructions.
NOTE
i
Fixture should be clamped vertically in vise to keep
housing seated against locator tool. 

7. REVISION SUMMARY
Revisions to this instruction sheet include:
• Changed company name and logo
Rev A
3 of 3