408-8780 Datasheet, PDF (3/4 Pages) TE Connectivity Ltd – Solder Assembly Kit 1055466-1

Fixture Frame
Thumb
Screw
Cable
Clamp
Inserts
408-8780
Positioning
Tool
Trimming
Holes
Spring
Figure 4
For 2.16
[.085] Cable
For 3.58
[.141] Cable
For 1.78
[.070] Cable
Figure 5
CAUTION
Center contact holders contains small amounts of
lead. The lead is used for assembly.
!
NOTE
i
Maximum operating temperature for the center
contact holder is 300°C [572°F].
DANGER
STOP
To avoid personal injury, be sure to observe all local
safety practices (including the use of gloves). The
solder gage, center contact holder, and the contact
may be hot after soldering.
6. USING LOCATING TOOLS
Solder Assembly Kit 1055466-1 contains four locating
tools. Refer to the connector specific instruction sheet
for selection of proper locator tool and assembly
instructions.
Type A, as well as Type B locating tools are available.
6.1. Using Type A Locating Tools
The solder assembly kit contains two Type A locator
tools. These tools are designed to be used with the
fixture subassembly. To insure proper connector
assembly, follow the instructions listed below.
1. Place connector housing on end of cable sub-
assembly. The subassembly refers to cable with
center contact.
2. Place loose connector assembly in fixture base.
3. Nest the center contact in locator tool.
4. Tighten the thumbscrew to secure the cable.
5. Tighten the locator tool to seat the cable firmly.
6. Slide connector housing over locator tool.
7. Maintain position of housing firmly against locator
tool.
Rev A
3 of 4