408-8581 Datasheet, PDF (3/3 Pages) TE Connectivity Ltd – crimping chamber crimps the center contact onto the center conductor of the coaxial cable.

408-8581
openings are correct, and (4) the tool has been
adjusted correctly.
5.1. Maintenance
1. Remove dust, moisture, and other contaminants
with a clean, soft brush, or a clean, soft, lint-free
cloth. DO NOT use any objects that could damage
the dies or tool.
2. Make sure that the proper retaining screws are
properly secured.
3. When the dies are not in use, store them in a
clean, dry area.
5.2. Inspection
1. Remove all lubrication and accumulated film from
the dies by immersing the dies in a suitable
commercial degreaser.
2. Make certain that all retaining screws and die
components are properly secured.
3. Inspect the crimping surfaces for flattened,
chipped, worn, or cracked areas. If damage is
evident, the dies must be replaced. Refer to Section
6, REPLACEMENT.
5.3. Measuring the Die Opening
Measure the die opening to ensure that it meets the
dimensions given in Figure 4.
6. REPLACEMENT
Order additional die assemblies through your
representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
A
±0.051 [.002]
B
±0.030 [.0011]
B
±0.030 [.0011]
DIE
ASSEMBLY
91911-1
91911-2
91911-3
91911-4
DIMENSION
A
B
4.395 [.1730]
0.457 [.0180]
3.580 [.1409]
0.472 [.0186]
2.845 [.1120]
0.510 [.0200]
2.845 [.1120]
0.380 [.0150]
Figure 4
7. REVISION SUMMARY
• Updated document to corporate requirements
• Added new artwork to Figure 4
Rev C
3 of 3