408-8500 Datasheet, PDF (3/4 Pages) TE Connectivity Ltd – Read these instructions and understand them before using the seating tool.

408-8500
5. MAINTENANCE AND INSPECTION
It is recommended that each operator be made aware of, and responsible for, the following steps of daily
maintenance:
1. Remove dust, moisture, and other contaminants with a clean, soft brush, or lint-free cloth. DO NOT
use objects that could damage the tool or any of its components.
2. Ensure that the screws are in place and secured.
3. When the tool is not in use, store it in a clean, dry area.
Each seating tool is assembled and inspected before shipment. It is recommended that the tool be inspected
using Figure 3 immediately upon arrival to assure that it has not been damaged during shipment.
Regular inspections should be performed by quality control personnel. A record of scheduled inspections
should remain with the tool or be supplied to personnel responsible for the tool. The inspection frequency
should be based on the amount of use, working conditions, operator training and skill, and established
company standards.
6. REPLACEMENT AND REPAIR
Order replacement seating tools through your local TE Connectivity Representative, or call 1-800-526-5142, or
send a facsimile of your purchase order to 717-986-7605, or write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
7. REVISION SUMMARY
 Updated document to corporate requirements
 Added new part numbers (91350-3, -4) and related information to table in Figure 3
Seating Tool 91347-[ ] (4-Pair Connector)
25.4
[1.00]
22.5
[.884]
B
D
E
C
4.44 [.175]
(F Places)
A
33.0 [1.30]
SEATING TOOL
91347-1
91347-2
91347-3
91347-4
91347-5
A
5.46 [.215]
5.21 [.205]
5.26 [.207]
5.18 [.204]
5.38 [.212]
B
15.49 [.610]
27.69 [1.090]
20.24 [.797]
15.19 [.598]
---
DIMENSION
C
25.4 [1.00]
37.34 [1.470]
29.97 [1.180]
49.78 [1.960]
12.70 [.500]
Figure 3 (cont’d)
D
---
---
---
30.18 [1.188]
---
E
---
---
---
40.18 [1.582]
---
Rev G
F
2
2
2
4
1
3 of 4