408-7994 Datasheet, PDF (3/4 Pages) TE Connectivity Ltd – Mass Termination Assembly

408-7994
Connector Centered
on Fixture Receiving
Track
Connector Ribs
Aligned with Slots
in Wire Combs
Front Wire
Comb
Connector Shoulder
Behind Fixture
Locating Plate
Rear Wire
Comb
Wires bottomed
in Wire Combs
Figure 4
4. Spread the fixture wire combs apart, and lift the
connector out of the fixture.
5. INSPECTING TERMINATED CONNECTOR
1. Visually inspect the connector to make sure that
there is no damage to the housing or contacts.
NOTE
i
For detailed inspection requirements, refer to
Application Specification 114-1019.

2. If applicable, test the connector for continuity
using the post retainer assembly.
NOTE
i
The post retainer assembly is only included with
some fixtures. Post Retainer Assembly 310672-1 is
available as an accessory for Fixtures 59844-1,
59845-1, and 59845-3 but cannot be used if the
fixture is used with the tooling assembly (58039-1).
6. REPLACEMENT AND REPAIR
Customer-replaceable parts are listed in Figure 5. 
A complete inventory should be stocked and
controlled to prevent lost time when replacement of
parts is necessary. Parts other than those listed should
be replaced by TE Connectivity to ensure quality and
reliability. Order replacement parts through your
representative, or call 1-800-526-5142, or send a
facsimile of your purchase order to 717-986-7605, or
write to:
CUSTOMER SERVICE (038-035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105-3608
For customer repair service, call 1-800-526-5136.
7. REVISION SUMMARY
Since the previous version of this document, the
following changes were made:
• Added information for fixture 58242-4.
• Updated document to corporate requirements.
Replacement Parts
ITEM
1
2
3
4
5
6
7
Rev C
PART NUMBER FOR FIXTURE
58635-1
58636-1
662732-1
662733-1
662734-1
662735-1
310325-1
2-21002-5
662736-1
6-23471-9
DESCRIPTION
BLADE, Locating
BASE
DOOR
COMB
SCREW, Button Head Cap, 10-32 x .25
SCREW, Special
SPRING, Torsion
Figure 5 (Cont’d)
QTY PER
FIXTURE
1
1
1
2
6
2
2
3 of 4