|
408-2833 Datasheet, PDF (3/4 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. | |||
|
◁ |
408-2833
Crimped Braid
Terminatiomn
Figure 6
97 mm 9.038 In. [Dia]
(Use No. 62 Drill]
3. Using a crimp height comparator, measure the
braid barrel crimp height as shown in Figure 8. If the
crimp height conforms to that shown in the chart,
the tool is considered dimensionally correct. If not,
refer to Section 6, CRIMP HEIGHT ADJUSTMENT,
for information on adjusting the crimp height.
For additional information concerning the use of the
crimp height comparator, refer to instruction sheet
408-7424.
6. CRIMP HEIGHT ADJUSTMENT (FIGURE 9)
1. Remove the lockscrew from the ratchet
adjustment wheel.
2. With a screwdriver, adjust the ratchet wheel from
the locator side of the tool.
3. Observe the ratchet adjustment wheel. If a tighter
crimp is required, rotate the adjustment wheel
COUNTERCLOCKWISE to a higher-numbered
setting. If a looser crimp is required, rotate the
adjustment wheel CLOCKWISE to a lower-
numbered setting.
4. Replace the lockscrew.
5. Make a sample crimp and measure the crimp
height. If the dimension is acceptable, replace and
secure the lockscrew. If the dimension is
unacceptable, continue to adjust the ratchet, and
again measure a sample crimp.
Figure 7
Screwdriver
Position Point onï
Center of Barrelï
Opposite Seam
Modifiedï
Anvil
PART NUMBER
DIE ASSY TERMINAL
220195-1
226854-1
226855-1
CRIMP HEIGHT âAâ (In. [mm])
BRAID
SECTION
INSUL SPT
SECTION
3.99 to 4.11
[.157 to .162]
5.3 ± .3
[.21 (±.01)]
4.24 to 4.37
[.167 to .172]
6.6 ± .3
[.26 (±.01)]
Figure 8
2. Refer to Section 4, CABLE PREPARATION AND
CRIMPING PROCEDURE, and crimp the terminal
accordingly.
Ratchetï
Adjusatmentï
Wheel
Lockscrew (Ref)
Figure 9
7. MAINTENANCE
Ensure that the dies are clean by wiping them with a
clean, soft cloth. Remove any debris with a clean, soft
brush. Do not use objects that could damage the dies.
When the dies are not in use, mate them and store the
Rev B
3 of 4
|
▷ |