408-9688 Datasheet, PDF (2/2 Pages) TE Connectivity Ltd – Practice the following steps on scrap cable lengths first.

408- 9688
4. Sharpen the blade using an oil stone or fine grit
grinding wheel — or — to obtain the replacement
blade, pull the slotted pin (located at the base of
the handle), stretching the spring; then immediately
rotate the pin 90_ exposing a small hole for blade
access.
DANGER ^{Wear safety glasses when using power tools.}
5. MAINTENANCE AND INSPECTION
To ensure proper operation, the tool and blade should
conform to the dimensions provided in Figure 4. It is
recommended that the tool be inspected immediately
on its arrival and at regularly scheduled intervals.
Clean the tool using a soft, lin--free cloth. Store the
tool in a clean, dry place.
5. Hold the “V” clamp open, and insert the blade
into the slot at bottom of the well.
6. Install the washer and spring, and position the
threads of the blade adjustment into the well.
7. Release the “V” clamp.
8. Screw the blade adjustment into the well until
the blade tip appears. Loosen the blade adjustment
by a half turn.
Replacing Blade
Blade Adjustment
Tool Dimensions
38.1 [1.5]
Note: Not to Scale
2.03 [.08]
0.76
[.03]
135
[5.312]
Spring
“V” Clamp (Open)
Top View
Well
Blade Slot
in Well
Replacement
Blade in Handle
Slotted Pin
Figure 3
24.1
3.3
[.95]
[.13]
Washer
Blade
Well
3.3
1.02
25.4
[.13]
[.04]
[1.0]
Figure 4
6. REPLACEMENT AND REPAIR
Order additional tools through your representative, or
call 1--800--526--5142, or send a facsimile of your
purchase order to 717--986--7605, or write to:
CUSTOMER SERVICE (038--035)
TYCO ELECTRONICS CORPORATION
PO BOX 3608
HARRISBURG PA 17105--3608
7. REVISION SUMMARY
Revisions to this instruction sheet include:
S Updated document to corporate requirements
S New logo
2 of 2
Rev B