408-8704 Datasheet, PDF (2/10 Pages) Tyco Electronics – Depress the upper release button located in the C–head and slide the nest into place.

408-8704
3. DIE INSTALLATION AND REMOVAL (FIGURE 2)
CAUTION
DO NOT operate the tool without the dies.
DANGER
To avoid personal injury, ALWAYS release hydraulic pressure to hose or control and disconnect power unit from power supply
before installing or removing dies.
Figure 2
3.1. Die Installation
1. Depress the upper release button located in the C-head and slide the nest into place.
2. Release the button and rock the die back and forth until the nest snaps in place.
3. Activate the power unit until the lower die release button located in the ram is exposed.
4. Depress the release button and slide the indenter into place.
5. Release the button and rock the indenter back and forth until the die snaps in place.
6. Return the ram to the down position.
CAUTION
To avoid damage to the dies, be sure that the moving and stationary dies are properly oriented.
3.2. Die Removal
Ensure that the possibility of accidental activation of the hydraulic power unit has been eliminated, and proceed
as follows:
1. Depress the upper release button located in the C-head and slide the nest out of the head.
2. Activate the power unit until the lower die release button in the ram is exposed.
3. Depress the release button and slide the indenter out of the ram.
Rev B
2 of 10