408-32241 Datasheet, PDF (2/3 Pages) TE Connectivity Ltd – Removal Kit 2215082-1 for Z-Pack TinMan Receptacles

408-32241
c. If a guide module is located next to the clamp assembly, the guide module pusher plate must be
installed.
Horizontal Pusher
Plate Orientation
Vertical Pusher
Plate Orientation
Figure 2
3.2. Removal Procedure
CAUTION
Be certain the removal tool assembly does not contact any components on the pc board during use.
1. Loosen the clamp knob on the clamp subassembly if necessary to fit over the receptacle.
2. Place the clamp subassembly over the receptacle and center it on the receptacle.
3. Tighten the clamp knob to clamp the receptacle. Hand tightening should be sufficient. See Figure 3.
Rear Clamp Plate
Front Clamp Plate
Clamp Knob
Figure 3
4. Place the pusher subassembly over the clamp subassembly. (Figure 4).
5. Tighten the Removal Knob to remove the receptacle from the pc board.
Pusher
Subassembly
Rev A
Figure 4
Clamp
Subassembly
2 of 3