English
Language : 

SRB Datasheet, PDF (1/5 Pages) MERITEK ELECTRONICS CORPORATION – Surface Mount Aluminum Electrolytic Capacitors
Corcom Product Guide
Catalog: 1654001
Issue Date: 06.2011
Minimum Depth, Cost-effective Shielded Power Inlet Filter
SRB Series
UL Recognized
CSA Certified
VDE Approved*
SRBP
SRBS8
SRB1
SRB2
SRB Series
Specifications
• Smallest depth Corcom RFI filter available
• Complete shield
• Wide range of capacitor values
• Attenuates coupled EMI up to 300MHz
• Minimal to low leakage current versions are
suitable for patient and non-patient contact
medical equipment.
• Full range of mounting and termination options
including unique vertical and horizontal
orientation slide in mounts eliminate the need for
mounting hardware
Ordering Information
15 SRB S 1 - Q
Capacitor ID
See Chart
Omit if none
Output Styles
1 – Spade terminals (back)
2 – Spade terminals (bottom)
8 – Wire leads
P – PC board pins
Maximum leakage current each Line to Ground:
@120 VAC
@250 VAC
Capacitor ID / Value
60 Hz
50 Hz
Blank / None
2 A
5 A
Q / 33 pF
2.1 A
3.65 A
R / 100 pF
9.6 A
16.6 A
S / 220 pF
19.2 A
33.2 A
T / 330 pF
24.0 A
41.5 A
W / 470 pF
0.04 mA
0.07 mA
X / 1000 pF
0.07 mA
0.13 mA
Y / 2200 pF
0.16 mA
0.28 mA
Z / 3300 pF
0.24 mA
0.42 mA
Hipot rating (one minute):
Line to Ground:
Line to Line:
2250 VDC
1450 VDC
Rated Voltage (max.):
250 VAC
Operating Frequency:
50/60 Hz
Rated Current:
15A*
Operating Ambient Temperature Range
(at rated current Ir):
-10°C to +40°C
In an ambient temperature (Ta) higher than +40°C
the
maximum
operating
current (Io)
follows: Io
is calculated as
= Ir (85-Ta)/45
Capacitor Options
3
Mounting Style
S – Snap-in
X – Slide-in (short edge / horizontal)
Y – Slide-in (long edge / vertical)
Omit for flange mount
SRB Series
Current Rating
15A
Capacitor ID
Q
R
S
T
W
X
Y*
Z*
Capacitor Value
33 pF
100 pF
220 pF
330 pF
470 pF
1000 pF
2200 pF
3300 pF
*15A versions are tested by Underwriters Laboratories
to US and Canadian requirements and are
VDE approved at 10A, 250VAC
Dimensions are in inches and millimeters unless otherwise specified. Values in italics
are metric equivalents. Dimensions are shown for reference purposes only.
Specifications subject to change.
*Not available in SRB8, SRBX or SRBY styles
203
For email, phone or live chat, please go to
te.com/help
corcom.com