55A0141 Datasheet, PDF (1/1 Pages) TE Connectivity Ltd – This specification sheet forms a part of the latest issue of Raychem Specification 55A.

SPECIFICATION CONTROL DRAWING ^SCD
Title
FOUR CONDUCTOR CABLE, UNSHIELDED, UNJACKETED,
Date
GENERAL PURPOSE, 600 VOLT
2-12-16
This specification sheet forms a part of the latest issue of Raychem Specification 55A.
COMPONENT WIRES - 55A0111
55A0141
Revision
E
PART NUMBER
1/
55A0141-30-*
55A0141-28-*
55A0141-26-*
55A0141-24-*
55A0141-22-*
55A0141-20-*
55A0141-18-*
55A0141-16-*
55A0141-14-*
55A0141-12-*
CABLE CONSTRUCTION DETAILS
CONDUCTOR
SIZE
(AWG)
30
28
26
24
22
20
18
16
14
12
OUTSIDE DIAMETER
(inch)
NOMINAL
.058
.065
.077
.090
.104
.121
.145
.165
.206
.249
MAXIMUM
.071
.079
.093
.106
.123
.142
.169
.191
.240
.289
MAXIMUM
WEIGHT
(lbs/1000 ft.)
2.7
3.7
5.7
8.2
11.4
17.5
26.5
33.9
53.0
80.4
CABLE RATINGS AND ADDITIONAL REQUIREMENTS
TEMPERATURE RATING: 150°C
Maximum continuous conductor temperature
VOLTAGE RATING: 600 volts (rms) at sea level
DIELECTRIC WITHSTAND: 1500 volts (rms), 60 Hz
INSULATION FLAWS:
Spark Test, 5.7 kV (rms) at 3 kHz
Impulse Dielectric Test, 8.0 kV (peak)
1/ PART NUMBER:
The "*" in the part numbers above shall be replaced by color
code designators with a slash separating the component wire
colors. Colors shown do not necessarily reflect the sequence
of manufacturing.
Example: AWG 22, black, brown, red, and orange
component wires: 55A0141-22-0/1/2/3
NOTE: Nominal values are for information only. Nominal values are not requirements.
Users should evaluate the suitability of this product for their application. Specifications are subject to change without notice.
Tyco Electronics Corporation also reserves the right to make changes in materials or processing, which do not affect compliance with any specification, without notification to Buyer.
1/ COLORS AND COLOR CODE DESIGNATORS SHALL BE IN ACCORDANCE WITH MIL-STD-681. HOWEVER, DUE TO LENGTH LIMITATIONS OF THE RAYCHEM PART NUMBER,
AN ALTERNATIVE COLOR CODE MAY REPLACE MIL-STD-681 COLOR CODE DESIGNATORS. (EXAMPLE: "901/902..." MAY BE REPLACED BY "Axxx".) OTHER CODES AND
SUFFIXES MAY BE ADDED TO THE PART NUMBER, AS NECESSARY, TO CAPTURE ANY ADDITIONAL REQUIREMENTS IMPOSED BY THE PURCHASE ORDER.
Page 1 of 1
Raychem, TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
DIMENSIONS ARE IN INCHES AND, UNLESS OTHERWISE DESIGNATED, ARE NOMINAL
THIS SPECIFICATION SHEET TAKES PRECEDENCE OVER DOCUMENTS REFERENCED HEREIN.
REFERENCED DOCUMENTS SHALL BE OF THE ISSUE IN EFFECT ON DATE OF INVITATION FOR BID.
Raychem Wire & Cable
501 Oakside Avenue
Redwood City, CA 94063-3800
Phone: [phone]
Fax: [phone]
© 2006-2016 Tyco Electronics Corporation. All rights reserved.