408-9999 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – PRO--CRIMPER III Hand Crimping Tool

PRO- CRIMPER* III Hand
Crimping Tool Assembly 58529- 1
with Die Assembly 58529- 2
I₄ns₀tru₈ct_-io₉n ₉Sh₉e₉et
11 AUG 14 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
Wire Side)
Pivot Pin
Die
Assembly
Moving Jaw
PRO- CRIMPER III Hand
Crimping Tool Frame
354940- 1 (408- 9930)
Ratchet
Adjustment
Wheel
The PRO- CRIMPER III Hand Crimping Tool is a “Commercial” grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 series specification, but may not comply with other feature
parameters of the specification. TE Connectivity offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1- 800- 722- 1111.
Stationary
Handle
Moving Handle
TE Die
Assembly
TE Locator
Assembly^a
Contact
Family^c
Size
(AWG)
58529--2
58515--1
AMPSEAL*
Contacts
16
18 to 20
a _{Supplied with the die assembly. Also available separately.}
c _{Call the Tooling Assistance Center or Production Information (see below) for product part numbers.}
Wire
Insul Dia
1.7 to 2.7
[.07 to .11]
Strip Length
(mm [In.])
5.15.1 á.4
[.20 á.02]
Figure 1
1. INTRODUCTION
PRO--CRIMPER III Hand Crimping Tool
Assembly 58529--1 consists of Die Assembly
58529--2 and PRO--CRIMPER III Hand Tool Frame
354940--1. The die assembly consists of crimping
dies and a locator assembly.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Read these instructions thoroughly before crimping
any contacts.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
2. DESCRIPTION (Figures 1 and 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
.2014 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 6
LOC B