English
Language : 

408-9992 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – PRO-CRIMPER* III Hand Crimping Tool Assembly
PRO- CRIMPER* III Hand
Crimping Tool Assembly 58521- 1
with Die Assembly 58521- 2
Instruction Sheet
408- 9992
19 OCT 11 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Stationary Jaw
Back of Tool
Wire Side)
Front of Tool
(Locator Side)
Pivot Pin
Die
Assembly
Moving Jaw
Ratchet
Adjustment
Wheel
The PRO- CRIMPER III Hand Crimping Tool is a “Commercial” grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate 114 series specification, but may not comply with other feature
parameters of the specification. TE Connectivity offers a variety of tools to
satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1- 800- 722- 1111.
PRO- CRIMPER III Hand
Crimping Tool Frame
354940- 1 (408- 9930)
Stationary
Handle
Moving Handle
TE Die
Assembly
TE Locator
Assembly{
Contact
Family}
Size
(AWG)
Wire
Insul Dia
18
1.98 to 2.59
[.078 to .102]
58521--2
58516--1
.070 Series
Contacts
16
2.18 to 2.59
[.086 to .102]
20
1.68 to 2.39
[.066 to .094]
{ SUPPLIED WITH THE DIE ASSEMBLY. ALSO AVAILABLE SEPARATELY.
} CALL THE TOOLING ASSISTANCE CENTER OR PRODUCTION INFORMATION (SEE BELOW) FOR PRODUCT PART NUMBERS.
Strip Length
(mm [In.])
3.48 to 4.50
[.137 to .177]
Figure 1
1. INTRODUCTION
any contacts.
PRO--CRIMPER III Hand Crimping Tool
Assembly 58521--1 consists of Die Assembly
58521--2 and PRO--CRIMPER III Hand Crimping Tool
Frame 354940--1. The die assembly consists of
crimping dies and a locator assembly.
Read these instructions thoroughly before crimping
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1--800--722--1111
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
1 of 6
LOC B