|
408-9967 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping Tool Assembly | |||
|
PRO-CRIMPER* III Hand Crimpingï
Tool Assembly 90872-1 withï
Die Assembly 90872-2
Instruction Sheet
408-9967
DEC 22 11 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assemblyï
(Supplied with Die ï
Assembly)
Front of Toolï
(Locator Side)
Die Assembly
Stationary Jaw
Back of Toolï
(Wire Side)
Pivot Pin
Moving Jaw
PRO-CRIMPER III Handï
Crimping Tool Frameï
354940-1 (408-9930)
Ratchetï
Adjustmentï
Wheeel
Stationaryï
Handle
The PRO-CRIMPER III Hand Crimping Tool is a âCommercialâ grade tool and is designed
primarily for feild installation, repair, maintenance work, or prototyping in industrial,
commercial, or institutional applications. Product crimped with this tool will meet the crimp
height requirements for hand tools found in the appropriate 114 series specification, but may
not comply with other features or parameters of the specification. Tyco Electronics offers a
variety of tools to satisfy your performance requirements. For additional information, contact
the Tooling Assistance Center at 1-800-722-1111.
Movingï
Handle
TE DIE
ASSEMBLY
90872-2
TE LOCATOR
ASSEMBLY
58516-1
CONTACT
FAMILYâ
.093 Commercial
Pin and Socket
SIZE
(AWG)
24-22
20-18
â Call the TOOLING ASSISTANCE CENTER or PRODUCT INFORMATION (see below) for part numbers.
Figure 1
WIRE
INSULATION
DIAMETER
2.79 [.110] Max
STRIP LENGTH
(mm IN.)
3.96 to 4.72
[.156 to .186]
1. INTRODUCTION
PRO-CRIMPER III Hand Crimping Tool Assembly
90872-1 consists of Die Assembly 90872-2 and ï
PRO-CRIMPER III Hand Crimping Tool Frame
354940-1. The die assembly consists of crimping dies
and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures and
illustrations are for identification only and are not
drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
2. DESCRIPTION
Refer to Figure 1 and Figure 2.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Companyï TOOLING ASSISTANCE CENTER 1-800-722-1111ï This controlled document is subject to change.ï
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 6
LOC B
|
▷ |