English
Language : 

408-9966 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping Tool Assembly
PRO-CRIMPER* III Hand
Crimping Tool Assembly 90871-1
with Die Assembly 90871-1 and -2
Instruction Sheet
408-9966
13 OCT 11 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with Die Assembly)
Front of Tool
(Locator Side)
Die Assembly
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
PRO-CRIMPER III
Hand Crimping Tool
Frame 354940-1 
(408-9930)
Moving Jaw
Ratchet
Adjustment Wheel
Moving Handle
Stationary
Handle
TE DIE
ASSEMBLY
TE LOCATOR
ASSEMBLY†
CONTACT
FAMILY‡
SIZE (AWG)
90871-2
58516-1
.093 Commercial
Pin and Socket
20-18
16-14
† Supplied with die assembly. Also available separately.
‡ Contact the Tooling Assistance Center or Product Information (see below) for specific contact part numbers.
WIRE
INSUL DIA
3.56 [.140] Max
STRIP LENGTH
3.96 to 4.72
[.156 to .186]
Figure 1
1. INTRODUCTION
PRO-CRIMPER III Hand Crimping Tool Assembly
90871-1 consists of Die Assembly 90871-2 and PRO-
CRIMPER III Hand Crimping Tool Frame 354940-1.
The die assembly consists of crimping dies and a
locator assembly.
2. DESCRIPTION (Figure 1 and Figure 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with two crimping
sections.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures and
illustrations are for identification only and are not
drawn to scale.
The die assembly features a wire anvil, an insulation
anvil, a wire crimper, and an insulation crimper.
Attached to the outside of the frame is a locator
assembly, which contains a locator, a spring retainer,
and a contact support.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 6
LOC B