English
Language : 

408-9911 Datasheet, PDF (1/3 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 7, REVISION SUMMARY.
Seating Tool 90752-1 for Z-PACK*
110-Position 2mm HM Pin Header
With ACTION PIN* Contacts
Seating Tool
Adapter
Instruction Sheet
408-9911
01 DEC 11 Rev B
Blade (2 Places)
Z-PACK 2mm HM Pin
Header 100143-1 (Shown)
ACTION PIN Contact
(110 Places)
Printed Circuit (PC) Board
(Ref)
PC Board Support Fixture
(Customer Supplied, Ref)
Figure 1
1. INTRODUCTION
Seating Tool 90752-1 is used to seat a 110-position 
Z-PACK 2mm HM pin header with ACTION PIN
contacts to allow solderless printed circuit (pc) board
installation. Read these instructions and understand
them before using the seating tool.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Dimensions are in millimeters [and inches].
Figures are not drawn to scale.
3. REQUIREMENTS
3.1. PC Board Support Fixture (Customer Supplied)
A pc board support must be used to provide proper
support for the pc board and alignment of the tool to
the pin header and to protect the pc board and pin
header contacts from damage. Design a pc board
support fixture using the recommendations in
instruction sheet 408-6927.
3.2. Application Tooling
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
2. DESCRIPTION
The seating tool is an assembly of two blades and an
adapter. See Figure 1.
During seating, the seating tool sits inside the housing
of the pin header with the blades engaging the
housing floor and contact shoulders preventing the
contacts from pushing out of the housing.
Power for the seating tool must be provided by an
application tool (with a ram) capable of supplying a
downward force of 133 N [30 lb] per contact.
Manual Electric Servo Presses (CMP 6T) 1585699-8
and (CMP 12T) 1585698-8, and Bench Top Electric
Servo Press (CBP 5T) 1585696-9 are available for this
seating tool. For information on the presses, visit the
press-fit assembly equipment website at 
http://tooling.te.com/pressfit.asp.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 3
LOC B