408-9885 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

PRO-CRIMPER* III Hand Crimping
Tool Assembly 90548-1 with
Die Assembly 90548-2
Instruction Sheet
408-9885
02 NOV 12 Rev G
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with Die
Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die Assembly
Moving Jaw
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Ratchet
Adjustment
Wheel
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial” grade tool and is designed
primarily for field installation, repair, maintenance work, or prototyping in industrial,
commercial, or institutional applications. Product crimped with this tool will meet the crimp
height requirement for hand tools in the appropriate 114 series specification, but may not
comply with other feature parameters of the specification. This company offers a variety of
tools to satisfy your performance requirements. For additional information, contact the
Tooling Assistance Center at 1-800-722-1111.
Stationary
Handle
Moving Handle
DIE
ASSEMBLY
LOCATOR
ASSEMBLY †
CONTACT
FAMILY ‡
SIZE (AWG)
WIRE
INSUL DIA
90548-2
58515-1
Universal
MATE-N-LOK*
Contacts
24-22
20-18
1.02 to 2.54
[.040 to .100]
† Supplied with die assembly. Also available separately
‡ Contact the TOOLING ASSISTANCE CENTER or PRODUCT INFORMATION (see below) for specific contact part numbers.
STRIP LENGTH
3.96 to 4.75
[.156 to .187]
Figure 1
1. INTRODUCTION
PRO-CRIMPER III Hand Crimping Tool Assembly
90548-1 consists of Die Assembly 90548-2 and
PRO-CRIMPER III Hand Crimping Tool Frame
354940-1. The die assembly consists of crimping dies
and a locator assembly.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures and
illustrations are for identification only and are not
drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
2. DESCRIPTION (Figure 1 and Figure 2)
The tool features a tool frame with a stationary jaw
and handle, a moving jaw, a moving handle, and an
adjustable ratchet that ensures full contact crimping.
The tool frame holds a die assembly with two crimping
sections.
The die assembly features a wire anvil, an insulation
anvil, a wire crimper, and an insulation crimper.
Attached to the outside of the frame is a locator
assembly, which contains a locator, a spring retainer,
and a contact support.
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 6
LOC B