408-9884 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools

PRO-CRIMPER* III Hand Crimping
Tool Assembly 90547-1 with
Die Assembly 90547-2
Instruction Sheet
408-9884
10 APR 15 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low
volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
Stationary Jaw
Die Assembly
Moving Jaw
Die Retaining Screw
(2 Places)
Pivot Pin
Back of Tool Frame
(Wire Side)
PRO-CRIMPER III Hand Tool
Frame 354940-1 (408-9930)
Ratchet
Ratchet Adjustment
Wheel
Stationary Handle
primarily for field installation, repair, maintenance work, or prototyping in industrial,
commercial, or institutional applications. Product crimped with this tool will meet the crimp
height requirement for hand tools in the appropriate Application Specification (114-series),
but may not comply with other feature parameters of the specification. TE Connectivity
offers a variety of tools to satisfy your performance requirements. For additional
information, contact the Tooling Assistance Center at 1-800-722-1111.
Moving Handle
DIE ASSEMBLY
PART NUMBER
LOCATOR
ASSEMBLY†
PRODUCT FAMILY‡
SIZE (AWG)
90547-2
58515-1
Universal MATE-N-LOK*
Contacts
20-18
16-14
† Supplied with die assembly. Also available separately.
‡ Call one of the numbers at the bottom of this page for contact part numbers.
Figure 1
WIRE SIZE
INSULATION
DIAMETER
3.30 to 5.08
[.130 to .200]
1. INTRODUCTION
This tool assembly is used to crimp the contacts onto the wires listed in Figure 1.
STRIP LENGTH
3.96 to 4.75
[.156 to .187]
2. DESCRIPTION
Tool features are shown in Figure 1.
NOTE
Dimensions in this instruction sheet are in millimeters [with inches in brackets]. Figures are not drawn to scale.
Reasons for re-issue of this instruction sheet are provided in Section 10, REVISION SUMMARY.
3. INSTALLATION AND REMOVAL OF DIE ASSEMBLY
1. Close the tool handles until the ratchet releases, then allow the handles to open fully.
© 2015 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 6