408-9875 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Base Assembly Universal

MANUAL ARBOR
FRAME ASSEMBLY
91085--2
Base Assembly Universal
Arbor Tool 768338- 2
Instruction Sheet
408- 9875
22 Mar 11 Rev A
SLIDE BASE
OF FRAME
ASSEMBLY
(Ref)
BASE
UPPER
TOOL
MOUNT
SLOT ON UPPER TOOL
MOUNT POSITIONED
TOWARD FRONT OF
FRAME ASSEMBLY
CABLE
STOP
CABLE
CLAMP
CONNECTOR
TYPES
CONNECTOR- SPECIFIC
KITS
AMPLIMITE* .050 Series
AMP- LATCH* Paddleboard
679235- 1 (408- 9892)
679176- 1 (408- 9928)
TOOL STOP
(Not Shown)
(Ref)
CABLE
GUIDES
FLUTED
PLATE
FRONT
GUARD
Figure 1
1. INTRODUCTION
These instructions cover installation, setup, and
termination procedures for Base Assembly Universal
Arbor Tool 768338--2. The universal arbor tool is used
with connector--specific kits (listed in Figure 1) to
terminate connectors onto .64 mm [.025 in.]
centerline ribbon cable. The tooling assemblies are
used in conjunction with Manual Arbor Frame
Assembly 91085--2 (see Figure 1) or Pneumatic
Auto--Cycle Unit 91112--3.
For information regarding the setup and operation of
the arbor frame assembly, refer to instruction sheet
408--7777 and 408--6732 for the auto--cycle unit.
Installation and setup procedures for the
connector--specific kits are available in 408--9928 (for
679176--1) and 408--9892 (for 679235--1).
Read these instructions (and other referenced
documents) thoroughly before terminating any
connectors.
NOTE
i
Dimensions are in millimeters [followed by
inches in brackets].
2. DESCRIPTION (Figure 1)
The universal arbor tool consists of an upper tool
mount and a lower tooling assembly. The lower
tooling consists of a machined base, a fluted plate,
two cable guides, a cable clamp, a cable stop, and a
front guard. The machined base allows the tooling to
be moved into and out of the crimping area of the
arbor frame assembly. The fluted plate is designed to
provide proper seating of the ribbon cable. The cable
guides aid in positioning the ribbon cable with the
connector assembly, and the cable clamp holds the
E2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1--800--722--1111
All Rights Reserved
PRODUCT INFORMATION 1--800--522--6752
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks.
*Trademark. Other logos, product and/or Company names may be trademarks of their respective owners.
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
1 of 4
LOC B