408-9819 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – Tool Assembly 58495-1 with

PRO-CRIMPER* III Hand Crimping
Tool Assembly 58495-1 with
Die Assembly 58495-2
Instruction Sheet
408-9819
05 MAY 11 Rev D
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
(Supplied with
Die Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die Assembly
Moving
Jaw
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (408-9930)
Ratchet
Adjustment
Wheel
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial" grade tool and is
designed primarily for field installation, repair, maintenance work, or prototyping in
industrial, commercial, or institutional applications. Product crimped with this tool will
meet the crimp height requirement for hand tools in the appropriate 114 series
specification, but may not comply with other feature parameters of the specification.
TE offers a variety of tools to satisfy your performance requirements. For additional
information, contact the Technical Assistance Center at 1-800-722-1111.
Stationary
Handle
Moving Handle
TE DIE
ASSEMBLY
LOCATOR
ASSEMBL†
58495-2
58515-1
† Supplied with die assembly. Also available separately.
CONTACT
FAMILY‡
Multimate
Type III(+) and
Type VI
Contacts
WIRE
SIZE
(AWG)
INSUL
DIA
STRIP LENGTH
(mm [In.])
28 - 24
.89 to 1.40
[.035 to .055]
24 - 20
1.02 to 2.03
[.040 to .080]
3.17
[.125]
18 - 16
2.03 to 2.54
[.080 to .100]
‡ Contact the Technical Assistance Center or Product Information (below) for specific
product information.
Figure 1
1. INTRODUCTION
PRO-CRIMPER III Hand Crimping Tool Assembly
58495-1 consists of Die Assembly 58495-2 and PRO-
CRIMPER III Hand Crimping Tool Frame 354940-1.
The die assembly consists of crimping dies and a
locator assembly.
Read these instructions thoroughly before crimping
any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures and
illustrations are for identification only and are not
drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 6
LOC B