English
Language : 

408-9750 Datasheet, PDF (1/4 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 6, REVISION SUMMARY.
Cover Lacing Fixture 91293-1 for
AMPLIMITE* .050 Series Connectors and
AMPMODU* 50/50 Grid Connectors
Instruction Sheet
408-9750
08 APR 11 Rev D
Upper Tooling
Assembly
Slots for Termination Covers
Slide Stop
Lacing Fixture
Subassembly
Slide Body
Combs
Adjustable Locator
Stationary Locator
Figure 1
1. INTRODUCTION
Cover Lacing Fixture 91293-1 is used with Manual
Arbor Frame Assembly 58024-1 to apply discrete
wires to AMPLIMITE .050 Series connectors and wire
lacing termination covers for AMPMODU 50/50 grid
connectors.
Refer to Instruction Sheet 408-6923 for the operating
procedure for the arbor frame.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
Reasons for reissue of this instruction sheet are
provided in Section 6, REVISION SUMMARY.
2. DESCRIPTION (Figure 1)
The fixture consists of a slide assembly, a lacing
fixture subassembly, and an upper tooling assembly
containing two 50-position and two 100-position
seating bars. Additional seating bars, purchased
separately, are available for applying 26- and 68-
position connectors.
The slide assembly consists of a slide body and a
slide stop. The slide body mounts to the base of the
manual arbor frame assembly and allows the lacing
fixture subassembly to slide back into position under
the upper tooling assembly. The slide stop, which is
used to position the lacing fixture subassembly under
the upper tooling assembly, is a thin bar of steel that is
fastened to the back of the slide at one of two
positions.
The lacing fixture subassembly consists of a U-shaped
base with slots to hold the termination covers. Each
slot has a stationary locator and an adjustable locator
that permit proper positioning of the termination
covers. Mounted onto the base are four combs (two
inner combs and two outer combs), which are used to
guide and hold the wires as they are pressed into the
termination covers during the termination procedure.
On the underside of the base is a cable clamp which
holds the jacketed cable while the wires from the cable
are being laced into the combs.
The upper tooling assembly features a tool mount, a
top plate, four seating bars, and two cutting blades.
The inner seating bars push the wires at the inside
edge of the termination cover. The center seating
bars, which push the wires down inside the
termination cover, must be installed to match the
termination cover size being applied.
The cutting blades help push the wires downward at
the outside edge of the connector, and then cut the
wires nearly flush with the connector edge.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 4
LOC B