408-8918 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – PRO-CRIMPER III

PRO- CRIMPER* III
Hand Tool Assembly 91388- 1
with Die Assembly 91388- 2
Instruction Sheet
408- 8918
17 JAN 12 Rev C
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use and low volume
applications. A wide selection of powered application equipment for extended- use, production operations is available.
Locator Assembly
(Supplied with Die
Assembly)
Front of Tool
(Locator Side)
Stationary Jaw
Back of Tool
(Wire Side)
Pivot Pin
Die Assembly
Moving Jaw
Ratchet Adjustment Wheel
PRO- CRIMPER III Hand Tool
Frame 354940- 1
(See Instruction Sheet 408- 9930)
The PRO- CRIMPER III Hand Tool is a “Commercial” grade tool and
is designed primarily for field installation, repair, maintenance work,
or prototyping in industrial, commercial, or institutional applications.
Product crimped with this tool will meet the crimp height requirement
for hand tools in the appropriate 114 application specification, but
may not comply with other feature parameters of the specification.
TE Connectivity offers a variety of tools to satisfy your performance
requirements. For additional information, contact the Tooling
Assistance Center at 1- 800- 722- 1111.
DIE ASSEMBLY
PART NUMBER
LOCATOR ASSY
PART NUMBER{
CONTACT
FAMILY}
WIRE SIZE,
AWG
Stationary Handle
Moving Handle
WIRE
INSULATION
DIAMETER
STRIP
LENGTH
91388--2
58516--3
4.2 mm
Contact System
22--18
1.50--2.41
[.059--.095]
2.79--3.30
[.110--.130]
{Supplied with die assembly, also available separately. }Contact the Tooling Assistance Center number at the
bottom of this page for specific contact part numbers.
Figure 1
1. INTRODUCTION
PRO--CRIMPER III Hand Tool Assembly 91388--1
consists of Die Assembly 91388--2 and
PRO--CRIMPER III Hand Tool Frame 354940--1. See
Figure 1. The die assembly consists of crimping dies
and a locator assembly. Read these instructions
thoroughly before crimping any contacts.
NOTE
i
Dimensions on this sheet are in millimeters [with
inch equivalents provided in brackets]. Figures
and illustrations are for identification only and are
not drawn to scale.
Reasons for reissue are provided in Section 11,
REVISION SUMMARY.
E2012 Tyco Electronics Corporation, a TE Connectivity Ltd. Company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1--800--722--1111 This controlled document is subject to change.
PRODUCT INFORMATION 1--800--522--6752
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 5
LOC B