408-8917 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – PRO-CRIMPER III Hand Crimping

PRO-CRIMPER* III Hand Crimping
Tool Assembly 91387-1
With Die Assembly 91387-2
Instruction Sheet
408-8917
16 MAR 12 Rev B
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
Locator Assembly
Additional Contact Support
Stationary Jaw
Pivot Pin
Die Assembly
Back of Tool Frame
(Wire Side)
Moving Jaw
Ratchet
Die Retaining Screw
(2 Places)
Ratchet Adjustment
Wheel
PRO-CRIMPER III Hand Tool
Frame 354940-1 (408-9930)
Stationary Handle
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial" grade tool and is designed
primarily for field installation, repair, maintenance work, or prototyping in industrial,
commercial, or institutional applications. Product crimped with this tool will meet the crimp
height requirement for hand tools in the appropriate Application Specification (114-series),
but may not comply with other feature parameters of the specification.
TE Connectivity offers a variety of tools to satisfy your performance requirements.
For additional information, contact the Tooling Assistance Center at 1-800-722-1111.
Moving Handle
DIE
ASSEMBLY
LOCATOR
ASSEMBLY ‡
ADDITIONAL
CONTACT
SUPPORT †
PRODUCT FAMILY
WIRE
SIZE
INSULATION
(mm [in.]) DIAMETER (mm [in.])
STRIP LENGTH
(mm [in.])
91387-2
58516-1
679277-1 4.2 mm Contact System
26-22 1.19-1.75 [.047-.069] 2.79-3.30 [.110-.130]
‡ Included with die assembly and available separately. † Included with tool assembly and available separately.
Figure 1
1. INTRODUCTION
PRO-CRIMPER III Hand Tool Assembly 91387-1
consists of PRO-CRIMPER III Hand Tool Frame
354940-1 and Die Assembly 91387-2. The tool
assembly is used to crimp the contacts listed in
Figure 1. For contact part numbers, contact
PRODUCT INFORMATION at the number at the
bottom of this page.
Read these instructions thoroughly before using the
tool assembly.
For additional information on the hand tool frame, refer
to 408-9930.
Reasons for reissue of this instruction sheet are
provided in Section 9, REVISION SUMMARY.
2. DESCRIPTION (See Figure 1)
The tool consist of a stationary jaw and handle, a
moving jaw and handle, and an adjustable ratchet that
ensures full crimping. The tool features a ratchet
adjustment wheel for adjusting the crimp height.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures are not drawn to scale.
The die assembly consists of a wire anvil, insulation
anvil, wire crimper, and insulation crimper. When
closed, the dies form two crimping chambers. Each
die is held in the tool frame by a single screw.
©2012 Tyco Electronics Corporation, a TE Connectivity Ltd. company
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 5