408-8678 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – Read these instructions thoroughly before using the tool assembly.

PRO-CRIMPER* III Hand
Crimping Tool Assembly 58546-1
and Die Assemblies 58545-[ ]
Instruction Sheet
408-8678
13 MAR 14 Rev E
PROPER USE GUIDELINES
Cumulative Trauma Disorders can result from the prolonged use of manually powered hand tools. Hand tools are intended for occasional use
and low volume applications. A wide selection of powered application equipment for extended-use, production operations is available.
PRO-CRIMPER III Hand Crimping
Tool 58546-1 Shown
Stationary Jaw
Front of Tool
Die Assembly
58545-1
Moving
Jaw
Ratchet
Adjustment
Wheel
The PRO-CRIMPER III Hand Crimping Tool is a “Commercial” grade tool
and is designed primarily for field installation, repair, maintenance work, or
prototyping in industrial, commercial, or institutional applications. Product
crimped with this tool will meet the crimp height requirement for hand tools in
the appropriate Application Specification (114-series), but may not comply
with other feature parameters of the specification. TE Connectivity offers a
variety of tools to satisfy your performance requirements. For additional
information, contact the Tooling Assistance Center at 1-800-722-1111.
Back of Tool
(Wire Side)
Pivot Pin
PRO-CRIMPER III Hand
Crimping Tool Frame
354940-1 (Instruction
Sheet 408-9930)
Stationary
Handle
Moving
Handle
DIE
ASSEMBLY•
58545-1
58545-3
58545-4
PRODUCT FAMILY‡
(SOLISTRAND*)
Terminal (Standard)
Terminal (Standard) and Butt Splice
Terminal (Long Barrel) or Butt Splice
Terminal Parallel Splice
SIZE (AWG)
22-14
12-10
22-14
22-14
WIRE
STRIP LENGTH
(mm [in.])
4.37-5.16 [.172-.203]
6.35-7.14 [.250-.281]
6.35-7.14 [.250-.281]
7.94-8.73 [.312-.344]
‡Contact the Tooling Assistance Center or Product Information (at the number listed below) for specific terminal and splice part numbers.
•See page 6 for die assembly cross reference.
Figure 1
1. INTRODUCTION
Die Assembly 58545-[ ] and PRO-CRIMPER III Hand
Tool 58546-1 are used to crimp SOLISTRAND
Terminals and Splices onto the wire size listed in
Figure 1. PRO-CRIMPER III Hand Tool Assembly
consists of Hand Tool Frame 354940-1 and Die
Assembly 58545-1.
Read these instructions thoroughly before using the
tool assembly.
NOTE
i
Specific part numbers for die set 58545-[ ] may be
used with other optional crimp tooling. Refer to
Figure 7 for specific relationships.
NOTE
i
Dimensions in this instruction sheet are in metric
units [with U.S. customary units in brackets].
Figures and illustrations are for reference only and
are not drawn to scale.
© 2014 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 6
LOC B