408-8580 Datasheet, PDF (1/5 Pages) TE Connectivity Ltd – Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.

SDE Crimping Die Assemblies
91902-1, 91907-[ ], 91908-1,
91909-1, 91910-[ ], and 1424050-1
Instruction Sheet
408-8580
08 NOV 16 Rev D
Die Retaining
Screw
Indenter Dies
Chamfered
Edges
Anvil Dies
Die Retaining
Pin (Qty: 2)
Ferrule
Crimping
Chamber
Die Retaining
Pin (Qty: 2)
DIE ASSEMBLY
91902-1
91907-[ ]
91908-1
91909-1
91910-[ ]
1424050-1
Die Retaining
Screw
Center Contact
Retaining Screw
PRODUCT
50-Ohm C, HN, N, and TNC COAXICON* Connectors
ARINC Size 8 Triaxial Contacts
SMA Series 50-Ohm RF Connectors
50-Ohm C, HN, N, and TNC COAXICON Connectors
50-Ohm BNC COAXICON Connectors
50-Ohm BNC Connectors
TOOL FRAME
354940-1
or
9-1478240-0
9-1478240-0
354940-1
or
9-1478240-0
1. INTRODUCTION
Figure 1
The SDE crimping die assemblies listed in Figure 1 are designed to crimp the products also listed in Figure 1.
The die assembly must be installed into the frame assembly listed in Figure 1. Refer to Instruction Sheet
408-9930 for information on the 354940-1, PRO-CRIMPER* III, frame assembly; and Instruction Sheet
408-8851 for information on the 9-1478240-0, SDE-SA, frame assembly.
NOTE
Dimensions in this instruction sheet are in metric units [with U.S. customary units in brackets]. Figures are not drawn to scale.
Reasons for reissue of this instruction sheet are provided in Section 8, REVISION SUMMARY.
2. DESCRIPTION
Each four-piece die assembly consists of two indenter dies and two anvil dies. When closed, the die assembly
forms two or three crimping chambers. The larger crimping chambers crimp the ferrule of the connector onto
the coaxial cable, and the smaller crimping chamber crimps the center contact onto the center conductor of the
coaxial cable. Each set of dies is held in the tool frame by two pins and a screw.
3. INSTALLATION AND REMOVAL
1. Close the tool handles until the ratchet releases, then allow the tool handles to open fully.
NOTE
The ratchet has detents with audible "clicks" as the handles are closed. The ratchet releases on the sixth "click."
2. Remove the two die retaining screws and four die retaining pins from the tool jaws.
© 2016 TE Connectivity family of companies
All Rights Reserved
*Trademark
TOOLING ASSISTANCE CENTER 1-800-722-1111
PRODUCT INFORMATION 1-800-522-6752
This controlled document is subject to change.
For latest revision and Regional Customer Service,
visit our website at www.te.com.
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product, and/or company names may be trademarks of their respective owners.
1 of 5