408-7995 Datasheet, PDF (1/6 Pages) TE Connectivity Ltd – Mass Termination Assembly

Front Wire Comb

Mass Termination Assembly (MTA) 
.156 Connector-Holding Fixture
Instruction Sheet
408-7995
22 SEP 11 Rev C
Rear Wire Comb
Locating Plate
Housing
Support
Polarizing Tab
.156 MTA CONNECTOR
Card Edge
CONNECTOR-HOLDING
FIXTURE
Feed-Through Closed End
59849-1
59848-1
59849-3
59848-3
Posted
58010-1
58010-2
58009-1
58009-2
With Locking Ramp and Without Polarization Tabs
59847-1
59847-3
59846-1
58244-3
With Locking Ramp and With Polarization Tabs
Without Locking Ramp and With or Without Polarization Tabs
For Testing (All Types)
58245-1
58245-2
58245-3
58244-1
58244-2
58244-3
MTA
APPLICATOR
ASSEMBLY
59843-1^†
58576-1
(408-4260)
59843-1^†
58576-1
(408-4260)
59843-1^†
58576-1
(408-4260)
59843-1^†
59843-1^†
58576-1
(408-4260)
MTA TOOLING
ASSEMBLY
58040-1^‡
--
† _{This applicator assembly must be used with Pneudraulic Tool 59809-2. The applicator assembly and pneudraulic tool are no longer available for new applications,ï€} 
however the fixtures can be used with existing applications.
‡ _{The tooling assembly must be used with Manual Arbor Frame Assembly 58024-1 (408-6923).}
Figure 1
1. INTRODUCTION
Mass Termination Assembly (MTA) .156 Connector-
Holding Fixtures listed in Figure 1 are designed to hold
.156 MTA connectors and discrete wires in position for
termination. The fixture is used with the MTA
applicator assembly or tooling assembly (also listed in
Figure 1). The fixtures are designed for feed-through
(wires are not cut) or closed end (wires are cut)
applications. The connectors are available with up to
26 contact positions on 3.96 [.156] centerline spacing.
NOTE
i
Dimensions in this instruction sheet are in
millimeters [with inches in brackets]. Figures are for
reference only and are not drawn to scale.
For information on operating the applicator or tooling
assembly, refer to the instruction sheet (indicated in
parenthesis in Figure 1) packaged with the tooling.
Read these instructions and referenced material
thoroughly before using the fixture.
Reasons for reissue of this instruction sheet are
provided in Section 7, REVISION SUMMARY.
©2011 Tyco Electronics Corporation, a TE Connectivity Ltd. Company TOOLING ASSISTANCE CENTER 1-800-722-1111 This controlled document is subject to change.
All Rights Reserved
PRODUCT INFORMATION 1-800-522-6752
For latest revision and Regional Customer Service,
*Trademark
visit our website at www.te.com
TE Connectivity, TE connectivity (logo), and TE (logo) are trademarks. Other logos, product and/or Company names may be trademarks of their respective owners.
1 of 6
LOC B